Pipless Test400?

BB doesn't reduce PIP unless your solution keep crashing and you injecting crashed product xD

In that case more BB will make it not crash. If you have a clear oil the issue is not in the recipe it's in the raw or concentration. Dilute it down and report back
Diluted it down to 300 and still causing heavy pip on 0.5ml delt pin, doesn’t give infection symptoms but definitely a sore lump. Gonna bin it as I don’t want to have to run 6ml a week of 250 or less.

Must’ve been the raw that was bad as the calculator is spot on and nothing in the protocol is incorrect. I’m going to try a test d/c blend at 400 see if fares better
 
Diluted it down to 300 and still causing heavy pip on 0.5ml delt pin, doesn’t give infection symptoms but definitely a sore lump. Gonna bin it as I don’t want to have to run 6ml a week of 250 or less.

Must’ve been the raw that was bad as the calculator is spot on and nothing in the protocol is incorrect. I’m going to try a test d/c blend at 400 see if fares better
OPs D/C blend recipe is solid even with my dodgy delt jab. Ran out of my own test e the other day and was due a jab so done another ml of it and no problem.
 
At that point might as well go straight for test D 500 or 550 Never understood the point of a 400 blend.
Was just to try lessen the amount of decanoate ester as it makes me hold a lot more water. I’m in the middle of a prep phase a professional bb so I don’t want to ideally switch too far from E/prop (separate pins) stack currently as keeps me dry enough until closer to comp when drop the time comes and ideally don’t want the long test still kicking about too much with longer half lives
 
OPs D/C blend recipe is solid even with my dodgy delt jab. Ran out of my own test e the other day and was due a jab so done another ml of it and no problem.
That’s what I was looking at going to use as nobody on here has said any way to get test E at 400+mg without pip. Well they say they know how but aren’t willing to share so cyp/E mix seems the next best thing to mitigate pip but still get the E in. I was also under the influence that Kurt havens cyp is bullshit compared to other esters was true but so far the consensus is 50/50
 
I have only experience with test U and I have pretty much used up my entire stash experimenting. The absolute highest I achieved zero crash is 380mg/ml in castor. 30℅ bb heated in its melting temperature long enough to ensure it fully holds. It still will crash if I let snow weather reach it ( dumb test but ensures room temp is enough)


400mg is possible but requires too much BB for my liking and it also ends up effecting the nice depot half life extension I was after
 
Back
Top