Questions about homebrewing

[IsaacClarke]

For Test E, tren A, Deca, and Mast E I was planning on using grapeseed oil and 2% Benzyl alcohol and 18% benzyl benzoate respectively. Test was going to be 250mg/mL, Tren at 100mg/mL, Deca at 200mg/mL, and Mast E at 100mg/mL. Each would have their own separate vials. I know some people try to mix all that shit but I don't like mixing my brews.

 

[IsaacClarke]

whoops forgot the actual question. Should I use different percentages of BB or BA for the different compounds?

 

[swerve]

If you are brewing mast e why only at 100 mg/ml...I would bump it to at least 200 mg/ml...

 

[swerve]

I usually do 2% & 20% on 95% of brews...there are a few exceptions

 

[Ddale]

I usually do 2% & 20% on 95% of brews...there are a few exceptions

What are those exceptions?

 

[XKawN]

Test e doesn't really need bb. Easy to dissolve into solution. Some people still use it mainly for viscosity reasons. 2% ba is overkill. I use 1% and have been for many years. Also, the higher the percentage of active ingredient without pip the better. Means less ml you'll be pinning and who wants to pin 3, 4 or more ml at a time when you can pin 1 or 2. I'd definitely go 200mg/ml on mast e and 300mg/ml on test e.

 

[caveman72]

I do 3%+ 15% ba3 bb15% unless hard like cypianate or primo ace.then 18 to 20% bb

 

[swerve]

What are those exceptions?

EQ for 1 because its in liquid form at room temp.

 

[Ddale]

EQ for 1 because its in liquid form at room temp.

Ok thanks

 

[IsaacClarke]

If you are brewing mast e why only at 100 mg/ml...I would bump it to at least 200 mg/ml...

because I don't want it to fall out of suspension or get cloudy because then no one will purchase it or trust it. I don't have any EO to dissolve it either since it's fuckin $70 for 500mL.

 

[IsaacClarke]

Test e doesn't really need bb. Easy to dissolve into solution. Some people still use it mainly for viscosity reasons. 2% ba is overkill. I use 1% and have been for many years. Also, the higher the percentage of active ingredient without pip the better. Means less ml you'll be pinning and who wants to pin 3, 4 or more ml at a time when you can pin 1 or 2. I'd definitely go 200mg/ml on mast e and 300mg/ml on test e.

Unless you guys are certain Mast E won't crash in 200mg/mL I was going to stick with 100. The Test E at 250mg/mL because I pin 500mg per week and it just makes it easier to calculate and once again I don't want it to crash

 

[IsaacClarke]

https://i.gyazo.com/90f3585fda7d2fc071dacbf8c870056c.png

 

[swerve]

Unless you guys are certain Mast E won't crash in 200mg/mL I was going to stick with 100. The Test E at 250mg/mL because I pin 500mg per week and it just makes it easier to calculate and once again I don't want it to crash

It will stay at 200 mg/ml