Reducing BA content of Gear

[scrappy]

HEy Guys,
I could really use some help. I have some gear where the BA is too high. Is there a way to heat it or evaporate off the BA? If not, is the only way to make this stuff tolerable to cut it with a bunch of sterile oil?
Any advice would be great from you chem buffs.
Thx

 

[hugewood]

HEy Guys,
I could really use some help. I have some gear where the BA is too high. Is there a way to heat it or evaporate off the BA? If not, is the only way to make this stuff tolerable to cut it with a bunch of sterile oil?
Any advice would be great from you chem buffs.
Thx

I have baked BA off of some poorly made homebrew before.... Set oven at 250 degrees and bake for 20 mins with a needle in the stopper to reduce pressure. If the gear was made correctly then removing some ba will probably make it crash and remember the BA is there to keep it sterile.

Good luck,
John

 

[chris gordon]

i would just get some planters 100% peanut oil and draw 1cc of it with 1cc of the bad gear

 

[andruw251]

I have baked BA off of some poorly made homebrew before.... Set oven at 250 degrees and bake for 20 mins with a needle in the stopper to reduce pressure. If the gear was made correctly then removing some ba will probably make it crash and remember the BA is there to keep it sterile.

Good luck,
John

so anytime you bake gear over 250 degrees, it gets rid of the BA??? i always bake my homebrew gear, and it has never crashed on me b4. my gear is usually painless, other than just a little pain from my prop