Researching busts on labs

tdad

New Member
AnabolicLab.com Supporter
Quoted from DEA special agent
Screenshot_20160514-181702.jpg Ignorance is abundant here.

Everything I've read published by "specialists" has been so far from any real facts.
Who pays these guys lmao
 
While roids ain't injected directly in veins or made in bathtubs (they are usually made in glass beakers), they ain't sterile.
Most sources don't even bother to filter their gear at all.

So the advice don't inject UG shit is still valid.
 
While roids ain't injected directly in veins or made in bathtubs (they are usually made in glass beakers), they ain't sterile.
Most sources don't even bother to filter their gear at all.

So the advice don't inject UG shit is still valid.

Where are you pulling that from? I find that VERY unlikely, as you would see particulate in a lot of the vials. This seems like a pretty bold claim, with no evidence to support it.
 
Where are you pulling that from? I find that VERY unlikely, as you would see particulate in a lot of the vials. This seems like a pretty bold claim, with no evidence to support it.

I agree with you WP, some UG may use a more porous filter to do it faster, but it would be obvious if it wasn't filtered at all. Lots of particles. The first time I dabbled in a home brew, I was doubting it before I filtered, then it looked ok...... For UG, if in doubt run it through a whatman filter anyway..
 
I agree with you WP, some UG may use a more porous filter to do it faster, but it would be obvious if it wasn't filtered at all. Lots of particles. The first time I dabbled in a home brew, I was doubting it before I filtered, then it looked ok...... For UG, if in doubt run it through a whatman filter anyway..
Not pretending to be a know-it-all

When in doubt, filter it
Just common sense
 
Back
Top