Simple question

Dave202000

New Member
so I am trying to filter some eminence shit (sust)I combined with old tren and cyp....anyway got the 22 micron and Benz alcohol and a 30mL vial anyway it's sealed but I accidentally pushed the base of the syringe into the stopper it shredded it a bit and my vial went on its side for a second in the boiling water (because I boiled the shit out of it cause the tren was cloudy and slimy) anyway it got a minuscule amount of boiled water in the vial I mean after boiling u can see maybe 10-15 droplets the size of the head of a needle around the neck of the inner part of the vial
So the question is after I boil bake for 275 degrees at 30 min and add the 10% BA (I don't care about the pain) will it be fine? I figure yes because BA and hear kill bacteria and sending it through another round of filtration should get rid of any spores should the tap water have had any
Keeping in mind this water was at a rolling boil for 15min prior to putting vial in.....I realize this doesn't get rid of spores but the filtering should yeah?

Lemme know your thoughts
 
Wtf, lol. 10% BA? First off, I use 1% BA but if your worried... throw in 2%. Second off, how many times do us vets gotta say... keep your junk away from the water. Why must folks keep touting this water bath crap. If you need to heat because you got swirls or something then a needle for ventilation and throw it in the oven. And if your brewing your perfectly fine putting your beaker directly on a hot plate. Water and oil don't mix.... literally.
 
Oh, and to answer your question, I doubt you'll have to worry about infection with 10% BA. yeah, your gonna wanna go to the hospital, but don't. Eventually it will pass.
 
I will do oven from now on
U think it will be good to re filter with another 20 micron? And bake?
That's what I'd do. The water won't kill you. And usually the water will separate from the oil so you might even be able to draw around it. But the 10%, man. If I were you I'd pin half a cc and give it a few days just to see how it goes.
 
I'll do the 2% BA for now
I saw some stuff about people saying tap water will kill u but honestly unless it's a spore I can't see gram neg bacteria killing you if u go to the hospital hav the wound drained and put on vancomycin
Now cryptosporidium maybe that's a diff story however a 20 micron will catch all but viruses even Protozoa so I think those dudes are referring to "whoops I got water in my test but I'll shoot it anyway"
 
I used a pot on a hot plate I was wary about heating the vial that way I didn't want it to crack not sure of its structure
 
So I'm about to refilter this stuff into another sterile vial it ended up being cloudy
When is the best time to add the BA? Do I add after filtration and then shake the vial or do I add BA then re filter? Also after that do I need to bake or is it good to go?
 
So I heated it and it was clear but as it cooled it turned cloudy not crashed but just cloudy with precipitation on neck of vial also it went from medium yellow to light orange wth
This is a mix btw
Tren ace
Test cyp
Sust

The sust and cyp began life clear and the tren medium Orange the mix was 20mL sust 8mL cyp and 5mL tren ace
I decided to mix them cause the cyp and tren were old and I was filtering the sust anyway I'm just wondering if it's oxidized now and no good
 
Add the BA when u mix everything in the beaker

I think your screwing with your own head... Its a very simple process to follow. Have it all written down and dont deviate from it
 

Sponsors

Back
Top