MESO-Rx

Anabolic Steroids

Solubility of DHT ? Conflicting information

If I were you, I'd just use the lower concentration. I doubt you can dissolve half a Gramm of DHT in 1 ml of DMSO, seems very unlikely.
 
Well I mixed 34 grams of DHT with a 75% DMSO 25% isopropyl alcohol solution, and the result is about 120ml of solution, with most of the DHT floating around as white powder, filling up over half the vials. So I heated to the melting point, so that it was a clear liquid with no white powder or crystals, and let it sit over night. This morning about 35% of the vial was filled with recrystallized DHT. I'm going to try to reheat and resuspend once more,but I think it may be about maximum concentration now for this amount of solvent.
 
You tried to dissolve it in dmso. I don't think you can inject dmso sounds risky. I tried to make dht into oil based injection. 2.5g I 50ml 30%bb 2%ba. Used peanut oil. Used mtc oil. Tried it with eo aswell total failure. I have injected it number of times tho. Without side effects except feeling totally horny.

It just doesn't dissolve you end up with crystals in finished filtered vials. It fully dissolve in dmso with ethonol tho for transdermal.
 
Jet Labs said:
Looking to make an oil based inject?
Click to expand...
Could you tell how to make an injectable solution of dht? i have tried adding 10% to a cypionate test mix but there is no way it will dissolve. I have used the same recipe as always 2%ba and 18%bb
thanks in advance
 
It crashes when you try to make it with BB or eo. It doesn't crash if you make it as transdermal with DMSO. You need proper lab equipment to make it properly. Look on Google patients there is lab method on the site.

If you make with BB it is ok to inject but is crashed gear tho.
 
beefcake1252 said:
You tried to dissolve it in dmso. I don't think you can inject dmso sounds risky. I tried to make dht into oil based injection. 2.5g I 50ml 30%bb 2%ba. Used peanut oil. Used mtc oil. Tried it with eo aswell total failure. I have injected it number of times tho. Without side effects except feeling totally horny.

It just doesn't dissolve you end up with crystals in finished filtered vials. It fully dissolve in dmso with ethonol tho for transdermal.
Click to expand...

@beefcake1252 Did you get any pain or PIP from injecting it?
 
No pip. just it has some crystals which means it has crashed. That's if you make it my way. Just seems doggy to inject. Don't know health affects.
 
beefcake1252 said:
No pip. just it has some crystals which means it has crashed. That's if you make it my way. Just seems doggy to inject. Don't know health affects.
Click to expand...

It won’t have any negative health effects. I’m going to make a batch with MCT and 30% BB.

Did it leave any lumps or knots after injecting?

If you heat it up does it disolve fine? I wouldn’t mind heating it up before each shot.
 
shanesheenie said:
It won’t have any negative health effects. I’m going to make a batch with MCT and 30% BB.

Did it leave any lumps or knots after injecting?

If you heat it up does it disolve fine? I wouldn’t mind heating it up before each shot.
Click to expand...
I've brewed DHT in MCT with no BB and no BA and it holds at 50mg/mL, I just always keep it on my coffee mug warmer. Zero PIP (as with all of my brews) whether IM or subQ.
 
Jire said:
I've brewed DHT in MCT with no BB and no BA and it holds at 50mg/mL, I just always keep it on my coffee mug warmer. Zero PIP (as with all of my brews) whether IM or subQ.
Click to expand...
What displacement weight did you give to the dht?
 
Zunbi said:
What displacement weight did you give to the dht?
Click to expand...
I don't understand what that concept is. I weigh the raw powder, put it into my vial, add the appropriate amount of carrier oil, tiny bit of BA, and cap the vial, then pressure cook at max for an hour.
 
Jire said:
I don't understand what that concept is. I weigh the raw powder, put it into my vial, add the appropriate amount of carrier oil, tiny bit of BA, and cap the vial, then pressure cook at max for an hour.
Click to expand...
Well, to know exactly how much oil, ba and bb to use as when you prepare other compounds and find the exact concentration you want
 
Jire said:
I've brewed DHT in MCT with no BB and no BA and it holds at 50mg/mL, I just always keep it on my coffee mug warmer. Zero PIP (as with all of my brews) whether IM or subQ.
Click to expand...
does dht leave you milky white?
I tried 50mg/ml with MCT oil and it was that color, it doesn't give me any confidence
 

Attachments

  • IMG-20221215-WA0009.jpeg
    IMG-20221215-WA0009.jpeg
    1 MB · Views: 16
You must log in or register to reply here.

Similar threads

B
Is aloe vera gel by itsself affective for transdermal application of dht
Replies
7
Views
331
bigbeancat
B
O
Best break down of oils solvents etc
Replies
8
Views
521
Pez'sAnabolicJunta
P
P
Self-Introduction
Replies
1
Views
36
sub10when
S
D
Test Iso 400
2
Replies
30
Views
901
Avies48
Avies48
dinfar1337
A comprenhensive tb500 frag thread
9 10 11
Replies
211
Views
6K
zneekah
Z

Sponsors

Latest posts

Back
Top