Support with pinning

Daz_900

New Member
Good evening all,

I haven't done cycle in many years after a lengthy lay off due to an injury.

I am going to be doing a basic testosterone enanthate cycle

Dose - 300mg to start (up to 400mg depending progress)

Duration - 12 weeks

Estrogen control - Arimidex

I will be pinning twice a week rotating between glutes & shoulders

PCT - HCG while Estee clears then nolva + clomid 4 weeks tampering down

My question I could use support with is pin size I used to pin with 25g 1 inch in glutes & shoulders but over 5 cycles found it more painful with scar tissue build up. I have been told by a few people (lean 8-12% body fat estimated) that a insulin pin 29g 0.5 inch or 5/8 inch would be just fine into those sites further helped if warm oil up to pass through with warm water?.

I am around 12% currently would this be to shallow I am looking for advice from people with experience using shorter pins ideally. Not concerned about longer time pushing oil but would be more comfortable with idea of shorter pins if I'm not going to have problems with oil lumps.

Thank you for any advice.
 
I pin with 30G, will never go back to the caveman days of 25g
Oil i pin 1inch, hgh i pin half inch.

Luer lok, 18g to pull the oil.

Also, your cycle length is borderline short. 16 would be better.
 
Just to confirm will be 2 pins per week between
I pin with 30G, will never go back to the caveman days of 25g

Luer lok, 18g to pull the oil.

Also, your cycle length is borderline short. 16 would be better.
Thank you,

Just to confirm 2 pins per week between 0.7ml & 1ml each this will be ok considering length of pin? 0.5 or 5/8 more recommended in this case?

Really appreciate the response & experience
 
Just to confirm will be 2 pins per week between

Thank you,

Just to confirm 2 pins per week between 0.7ml & 1ml each this will be ok considering length of pin? 0.5 or 5/8 more recommended in this case?

Really appreciate the response & experience
Brother, I pin 3 times a day. 2 per week is nothing
You will want 1 inch for oil, im low bf and .5 is barely enough for my delts and if you are talking about doing it other places, your gonna want 1 inch to not get oil bumps.
 
1ml 28g 1/2” insulin needle is what I use but I wouldn’t do your glutes. I’d do leaner body parts that you can get into the muscle. I hit rear and side delts, quads and lats. When I inject I push the needle down about 1/2” into the skin as I inject to get it a little deeper.
 
1ml 28g 1/2” insulin needle is what I use but I wouldn’t do your glutes. I’d do leaner body parts that you can get into the muscle. I hit rear and side delts, quads and lats. When I inject I push the needle down about 1/2” into the skin as I inject to get it a little deeper.
Thank you,

I am struggling to find places where I can get lua lock syringes. I always used the exchange before but it's closed where I am.

Any DM possible of reliable place don't mean to break any rules but if isn't safe (as can be) I'll just pass the stack
 
I pin everyday 0,62ml with 29G half inch insulin syringe. I rotate between side delts, rear delts and pecs and currently i'm above 12% bf.

There's no reason doing glutes, with that amount of volume you could just stick to side and rear delts only and you'll be more than fine.

If you plan pinning between 0,7 to 1ml as you said then pin Monday right side delt, Thursday left side delt, Monday rear right delt, Thursday left side delt and keep the same pattern. It's almost impossible to create scar tissue with that frequency, oil volume and needle size.
 
Back
Top