test-c/test-e at higher dosages

[swole4ever]

I have read that you should only make test-c at 200mg or it will crash easily. I have seen vials out there from ugl's that are dosed at 250. Lets say you make some test-c at 250-300 using the powder calculator and it crashes, what can you do to stabilize it? Add more bb????

There has to be an answer.

Thanks

 

[Purge]

I've seen recipes that use ethyl oleate (EO) as a cosolvent. One test c @ 400 mg/ml used 50% EO + 50% GSO as the carrier, then the typical BA/BB additives.

 

[swole4ever]

I've seen recipes that use ethyl oleate (EO) as a cosolvent. One test c @ 400 mg/ml used 50% EO + 50% GSO as the carrier, then the typical BA/BB additives.

I am still looking to find recipes like that. I wonder how much 50% EO comes out to be. I looked for a calculator but never did find one. I guess I have a lot more searching to do to find some of those recipes.

 

[beedix]

Of the carrier oil amount from the calculation, use 50% EO and 50% of your favorite oil. IMO, 300+ for me is "can't walk" levels of pip.

There are also some 500-750mg recipes using a super solvent Like guicuiol (spelling)

 

[Big_paul]

I have read that you should only make test-c at 200mg or it will crash easily. I have seen vials out there from ugl's that are dosed at 250. Lets say you make some test-c at 250-300 using the powder calculator and it crashes, what can you do to stabilize it? Add more bb????

There has to be an answer.

Thanks

test e or cyp using 20% bb you can easily produce 400mg/ml. easy. test p on the other hand never more than 100mg/ml because it is much more difficult to dissolve. who ever told you that was mistaken. i have done it many many times. never had a problem. never crashed any. 1% ba and 20% bb. no problem.
test e and c come in a gel form p is always powder.

 

[Big_paul]

dont use the powder calc on this one, it's wrong. not much room for oil but it works every time. thats not to say 400mg/ml is best. i would produce at 250 mg/ml for myself. try it you will like it dissolve 2.5 grams in a 10ml vile, then top it off with the oil of your choice. i like sesame oil for slow release test.

 

[Holl]

Test C is much more difficult than E....you can brew Test Enanthate easily at 300mg/ml with nothing more than BA. I run it at 3% BA, 0 BB and it is fine. In my opinion the half life is not that much different considering almost everyone will pin twice a week anyways.

This whole 18 or 20% BB thing is a relic from people using the default standard in powder calculator.