test crystals?

[jorge]

I bought some gear from a reputable source here about three months ago. I stored the vial. There was a fine layer of powder on the bottom of the vial today when I got the gear out. Has the test separated from the oil? How do I get the powder to dissolve again?

 

[JonTest]

I bought some gear from a reputable source here about three months ago. I stored the vial. There was a fine layer of powder on the bottom of the vial today when I got the gear out. Has the test separated from the oil? How do I get the powder to dissolve again?

bro just warm it up and shake vigorously....see what happens..

 

[joe shmoe]

try running hot water over it and shaking it.

the other method, if that doesnt work, is to boil some water. after it has boiled, turn off the heat. take an 18-20 gauge needle off a syringe and push it through the stopper...this will act as a vent. put the vial into the boiled water for a few sconds. remove and shake. repeat in necessary.

have a nice day

 

[highoutput]

I've had this same problem. What causes this?

 

[joe shmoe]

its caused, usually, by extreme cold. i got some test that was shipped during a cold spell in the east....single digit temps. it separated. after warming it up...WHAMO!...good as new.

have a nice day

 

[liftheavy54]

the hot water trick works well for me. I always heat up my vitamins this way before using.

 

[jorge]

try running hot water over it and shaking it.

the other method, if that doesnt work, is to boil some water. after it has boiled, turn off the heat. take an 18-20 gauge needle off a syringe and push it through the stopper...this will act as a vent. put the vial into the boiled water for a few sconds. remove and shake. repeat in necessary.

have a nice day

Thanks. I used some common sense and my experience making Tren. I used the boiling water method. This water boiling is one of the steps in the home brew. It worked first time out. Started the cycle last night! Thanks guys.

 

[stevemac]

yea, my prop looks like that now. its not really a powder but looks like small cylindrical crystals. i tried running under hot water and shaking but didnt really work, i gotta try again though and try the boiling method.