Test cyp brew issue thoughts needed

[Holidaypay]

Ok so I brewed 100 ml test cyp at 250 mg/ml I did the 2/18 recipe an let it sit for a day I noticed that the next day it still was crashed now here's the thing I ordered a 25 gram pack of cyp along with other things I didn't weigh the cyp because I was being lazy an everything else I ordered was good 2 go so I'm assuming the bag I used was a liytle overweight an I added 5 ml more of oil an 1 ml more of bb an let it sit again for a day most of it went into solution but there is still a little raw showing should I just repeat what I'm doing till its gone an I know that it was dumb to not weigh it but I had a lot of easter shit i was preparing an I was being lazy any advise is appreciated

 

[Holidaypay]

That's all thats left out of the 25 + an there is stuff on bottom of glass not in it lol

 

[penche]

I’d add 2ml more BB and apply some dry heat. Would not go over 225* in temp. Intervals of 5-7 min inside the heat and stir with glass rod. It will dissolve the crystals and the extra 2ml with help hold the hormone from crashing.

I’d def start weighing everything instead of rushing through your process tho @Holidaypay just to be safe and thorough.

 

[ickyrica]

Touch of BB and a little heat.

 

[Holidaypay]

I’d add 2ml more BB and apply some dry heat. Would not go over 225* in temp. Intervals of 5-7 min inside the heat and stir with glass rod. It will dissolve the crystals and the extra 2ml with help hold the hormone from crashing.

I’d def start weighing everything instead of rushing through your process tho @Holidaypay just to be safe and thorough.

Touch of BB and a little heat.

Thanks guys gna do it ton will update
An penche ur right the one time I cut corners to save time an i lost 10 × the time I saved

 

[Monstar]

Heat and stir - magnetic stirring hotplates are great for this. If you need to add anything more than just a bit of BB or as said above add it first before heating.

As long as BA is > 1% you are still fine post filtering and you haven't doubled the solution yet so cool.

In the future you can even weigh it in the bag to see if it's remotely near what's expected.

 

[Holidaypay]

I added 1 ml of bb an 100 degrees for ten mins last night it dissolved perfectly it is good so far gna wait till ton an bottle if it stays good thanks everyone

 

[TRTvegan]

There should of been no crashing .

I go to 55°c and have no problems at all.

 

[ickyrica]

Lots of variables go into a successful brew (or unsuccessful). I've had different outcomes with cyp when using the same raws and BB/BA but using a different brands mct oil. Pay attention and keep notes.