Test E 300-400 advice.

[codro82]

I have read that Test Enanthate is soluble in just the carrier oil but only seen this for up to 250mg. If wanted to to a batch between 300 and 400 would I need a solvent at that concentration. I know everyone is gonna scream PIP and I get that. But I have ran 300 and 350 in MCT Oil and I haven't had any PIP unless I pin too shallow and some goes sub q. Ran 27 g 5/8 slin pins with 0 issue. Any advice ? Thanks

 

[strixsir]

it sounds like you have a good personal tolerance, Got for it

worst could be that the solvent ratio was so incorrect that the solution is caustic, you get an abscess which causes the localized infection enters your bloodstream causing Sepsis,

at 400, the solution is prone to being supersaturated and unstable, it high increased probability that it crashes inside your body after injection forming lumps causing cough FOR days from blocked capillaries in the lungs