Testosterone Enanthate Powder Conversion Recipes

hugeraw

Banned
Testosterone Enanthate Powder : 5 grams

Produces: 20 ml @ 250 mg/mlRequirements:

· 5 grams testosterone enanthate

· 15.25 ml sesame oil

· Benzyl Alcohol 1ml 5% BA

· Syringes 3cc & 5/10cc

· 18 or 20 gauge needles

· Vial

· Sterile Vial

· Whatman sterile filter

Procedure:

· measure 5 grams of powder

· place the powder in the vial

· add BA to the vial

· heat the oil in a suitable container in the oven to a minimum of 212 degrees F to sterilise it

(it will likely be necessary to use slightly more oil than listed as you will not be able to utilise all of it)

· add the oil to the vial but save 2 ml of oil in the syringe for later

· gently shake the vial.

· reheat the mixture if necessary by placing the vial in a frying pan and place it on the eye of the stove

· place an 18 or 20 gauge needle in the sterile vial and attach the Whatman sterile filter

· place another needle in the sterile vial to relieve the pressure

· draw out the solution with a syringe and run it though the Whatman filter

· take the other syringe with 2 ml of oil (saved previously) and run it through the Whatman filter into the solution.


Testosterone Enanthate Powder :10 gramsProduces: 40 ml @ 250 mg/mlRequirements:

· 10 grams testosterone enanthate

· Benzyl Alcohol 2ml 5% BA

· 30.5 ml sesame oil

· Syringes 3cc & 5/10cc

· 18 or 20 gauge needles

· Vial

· Sterile Vial

· Whatman sterile filter

Procedure:

· measure 10 grams of powder

· place the powder in the vial

· add BA to the vial

· heat the oil in a suitable container in the oven to a minimum of 212 degrees F to sterilise it

(it will likely be necessary to use slightly more oil than listed as you will not be able to utilise all of it)

· add the oil to the vial but save 2 ml of oil in the syringe for later

· gently shake the vial.

· reheat the mixture if necessary by placing the vial in a frying pan and place it on the eye of the stove

· place an 18 or 20 gauge needle in the sterile vial and attach the Whatman sterile filter

· place another needle in the sterile vial to relieve the pressure

· draw out the solution with a syringe and run it though the Whatman filter

· take the other syringe with 2 ml of oil (saved previously) and run it through the Whatman filter into the solution.
 
I tend to like/stick with 18-20% BB and 1-2% BA, 2% TOPS.
Its an old but tried and true recipe that works at most all "normal" strength dosages.
Just how I have always done it.
 
I get all of my testosterone Enanthate from your competitor in India...or China.
 
This guy is only here to push his bunk powders.....

PAY NO ATTENTION TO MIKElikesHUGERAWcocks
 
Back
Top