time at the melting point

[strangegenericguy]

While brewing the products how much time should i let stay my solution at his melting point?

 

[HereToTeachAndLearn]

While brewing the products how much time should i let stay my solution at his melting point?

In most cases you do not need to go as high as the melting point. You only want to gradually apply enough heat for the powder to fully dissolve.

 

[strangegenericguy]

In most cases you do not need to go as high as the melting point. You only want to gradually apply enough heat for the powder to fully dissolve.

so typically for test c the melting point is between 98 and 104 so i go up from 60/70 for a decent amount of time until i see the powder is fully dissolved?

 

[strangegenericguy]

The thing is that i don't want to risk to ruin the powder letting stay the solution too much on the heat plate

 

[HereToTeachAndLearn]

The thing is that i don't want to risk to ruin the powder letting stay the solution too much on the heat plate

At the heat level you will be using, there is absolutely no way to damage most powders. Testosterone has been tested after applying 80C of heat for 48 hours and found to have no degradation.

Don't overthink the process. If you follow the steps, there is little chance for errors.

 

[strangegenericguy]

At the heat level you will be using, there is absolutely no way to damage most powders. Testosterone has been tested after applying 80C of heat for 48 hours and found no degradation.

Don't overthink the process. If you follow the steps, there is little chance for errors.

Apprecciated the help, usually how much time do i Need to dissolve the Powder for test c?

 

[HereToTeachAndLearn]

so typically for test c the melting point is between 98 and 104 so i go up from 60/70 for a decent amount of time until i see the powder is fully dissolved?

That will generally work. It will actually take you less time to fully dissolve than you actually think.

I set a temperature and generally walk away for 30 minutes, with an magnetic stirrer of course. Generally, depending on what raw I am brewing, it will be fully dissolved when I return. If not, I will raise the temp a bit, about 10C, and leave for another 30 minutes and come back. Generally, in the worst cases that takes care of it.

I just realized I used the word GENERALLY four times in the last two paragraphs. Thanks God my brewing skills are slightly better than my writing skills. At least I hope so.

 

[strangegenericguy]

That will generally work. It will actually take you less time to fully dissolve than you actually think.

Apprecciated again!

 

[narta]

You got into homebrewing?!?

 

[strangegenericguy]

You got into homebrewing?!?

Yeah what is the problem?

 

[narta]

Yeah what is the problem?

Not a thing...

It should be fun!

 

[strangegenericguy]

Not a thing...

It should be fun!

It Is not so difficult to do the homebrew i don't see any problem
Ba
Bb
Mct
Powder
Filters
The plate
Right amount of everything
You are done.

 

[narta]

It Is not so difficult to do the homebrew i don't see any problem
Ba
Bb
Mct
Powder
Filters
The plate
Right amount of everything
You are done.

 

[strangegenericguy]

Serious, where do you see the difficult? Maybe you give me a good advice

 

[narta]

Serious, where do you see the difficult? Maybe you give me a good advice

Maybe @Sampei can help because of the language barrier

 

[strangegenericguy]

Maybe @Sampei can help because of the language barrier

I Will be Happy if he does it even if i think i have It all clear in my mind, It doesn't seem Crazy difficult tbh