Tren Sludge

[nolimitz]

This is from tren ace raws. Typical 2% ba, 20% bb, mct which worked before.

This has been posted about before but I don't think we were able to figure out why this happens. The tren falls out of solution and starts to harden into a clump of sludge.

When I first got the raws I was able to brew it without any issues. Then after storing it away for sometime, the 2nd brew produced a sludge. What is happening to the raws from oxidation?
Someone said, its due some tren base being in the raws but can that naturally happen from long term storage?

It looks like I'll probably not be able to use the raws. However I still have a decent amount left so I'm going to try a few different recipes to see if it clears up.

 

[TideGear]

Let it sit for a few days and filter it cold

 

[Iron Vett]

I’ve started brewing all Tran ace raws when received because of the sludge problem. Actually, I just brew all raws when received

 

[nolimitz]

I diluted the concentration down to 50mg/ml by adding some EO and added in 2% guaiacol. It seems to be breaking down the sludge into a cloudy solution. I'm thinking about picking up some mig-840 to see if it'll help with keeping it in solution.

 

[baddaddee]

I diluted the concentration down to 50mg/ml by adding some EO and added in 2% guaiacol. It seems to be breaking down the sludge into a cloudy solution. I'm thinking about picking up some mig-840 to see if it'll help with keeping it in solution.

Don't think Mig will help. Had the same thing happen using only mig and 2/18

 

[FR0Z3N_B0MB3RRR]

I had the same issue with PPL tren a , i used too much heat too.. i didnt feel anything of common sides and effects.. no night sweats no cough no nothing.. i Just wasted a lot of money... i rebought some tren ace from PPL and will try to brew it in some ways 1g at a time.. @PandaRep do you know if this problem could be avoided without guaiacol? Panda himself said to raise BB to 22% and adding some Tren E.. i raised BB and added guaiacol too (dont wanna use it anymore btw) but didn’t add tren e..

 

[notanothersnake]

Just overdose it when you mix raws, to make the difference of loosing raws that turned into sludge. Filtering may be a bitch though

 

[PandaRep]

The picture looks like it's been burnt.
Tren needs little to no heat at all to brew.
And typically 100mg at 2/20 holds fine and goes into solution without really any heat.

Sides, the presence or lack of sides isn't an indication of the potency of tren. Personally I've run tren and have both had, and not had those sides while having the same results. If you look into it further you'll see that option echoed that sides don't really dictate the strength or validity of the compound.

@nolimitz what recipe did you use? What was you mg/ml target?

 

[TideGear]

Your only option is probably gonna be to filter it after it has cooled for a day or two. You'll end up with a better looking product, but idk how potent it will be. Sometimes tren ace raws just won't hold. I've only had one batch that did this but I don't think it was as bad as yours.

 

[monichi]

To not burn your raw don't use a cheap hot plate that is used for cooking and not for homebrewing !
This is shit ->

This is it ! (it's a progressiv hot and stir plate) ->
Another method is to warm the oil without your raw
and after that you add your raw, bb and ba
And to conclude, you filter when the finished oil is below 40°C !