Venom Lab
Subscriber
I'll offer both option
if it holds. I have been very busy and could only brew the EO/castor version.Soon will do full castor and full EO.
And compare the three.
MESO-Rx
Anabolic Steroids
Venom Lab Boutique - AAS - HGH and Peptides - EU Domestic
- Thread starter Venom Lab
- Start date
if it holds. I have been very busy and could only brew the EO/castor version.Soon will do full castor and full EO.
And compare the three.
Venom Lab
Subscriber
So 50/50 castor/EO doesn't crash almost. What I mean is you can see with a black light tiny minuscle almost invisible few speck of crystal but like srsly it took me 5 minutes to notice.
So probably it takes 2 minutes on a mag warmer to fix it.
But still not 100℅ perfect.
Next is the turn of full EO and full castor to see if anything changes.
While doing those I'll raise solvent content by 5% on a new batch of EO/Castor.
I have a bunch of half crashed anadrol btw, I'll sell them for cheap to anyone interested, it basically holds no problem if you uncrash it and keep it in a warm baby wiper or you can just uncrash it everytime before pinning. Because of this it will be heavily discounted for anyone that doesn't care much of the hassle of it.
It could maybe that there is no way to have it perfectly uncrashable 100℅ and if you guys want anadrol, 50mg without guiacol you will have to put up with a little bit of warming it before injecting.
But before arriving to this let me work on it and see what I can come up with
I'm quite sure EO 100% will work, I would like to find a way to make it work with MCT or Castor tho or a mix of the two.
So probably it takes 2 minutes on a mag warmer to fix it.
But still not 100℅ perfect.
Next is the turn of full EO and full castor to see if anything changes.
While doing those I'll raise solvent content by 5% on a new batch of EO/Castor.
I have a bunch of half crashed anadrol btw, I'll sell them for cheap to anyone interested, it basically holds no problem if you uncrash it and keep it in a warm baby wiper or you can just uncrash it everytime before pinning. Because of this it will be heavily discounted for anyone that doesn't care much of the hassle of it.
It could maybe that there is no way to have it perfectly uncrashable 100℅ and if you guys want anadrol, 50mg without guiacol you will have to put up with a little bit of warming it before injecting.
But before arriving to this let me work on it and see what I can come up with
I'm quite sure EO 100% will work, I would like to find a way to make it work with MCT or Castor tho or a mix of the two.
Venom Lab
Subscriber
Good news, thanks to a friend brain (you know who you are, you little genius) we may have found a way to have perfectly stable Anadrol 50mg without the need of any EO.
Will report back next week after I have experimented with it!
I'm excited like a kid the night before Christmas
Will report back next week after I have experimented with it!
I'm excited like a kid the night before Christmas
Me to if this is realy possible
Ethyl lactate?
Eddie.
Member
First order received in about 7-8 calendar days total. I asked for a specific brew, the first 5 vials with dark colour are Test D300mg/ml in GSO. Venom prepared the order in just 24h!! Then I have inj Dbol, 2 tren A and 1 test D500.
Communication was solid and opsec was more than enough! All vials were labelled which obviously I removed for making this post, vacuum sealed and handled with care.
Tomorrow I’m gonna try the dbol and next day test D and tren.
Communication was solid and opsec was more than enough! All vials were labelled which obviously I removed for making this post, vacuum sealed and handled with care.
Tomorrow I’m gonna try the dbol and next day test D and tren.
Venom Lab
Subscriber
Hopefully the test D in GSO will treat you well.
Thanks for the feedback, enjoy the gear
Last edited:
Venom Lab
Subscriber
Guys one thing for all my clients.
It's winter time and temperatures are dropping, especially on many destinations in the north the temperatures can be challenging for the gear to stay in solution and not crash.
The thing is that especially with high concentration gear is a very fine balance between making a product with enough solvents to be smooth and stay in solution at normal temperature or overweight the solvents to make it uncrashable but that would be in my opinion a sloppy work. Anyone can just overdose the solvents part well over what's needed just to make it easy.
As I strive to offer a good balance between % of solvents and carrier oil, as I don't use EO in any standard recipes, while keeping the first at a minimum you must understand that yes some of the vials will arrive and be crashed.
Now the important part, I'll not be too technical but the thing with crashed gear and formation of crystals is this.
You need to heat it well to keep it from crashing again, so the suggestion is buy a mug warmer (10/15€ on amazon) or use your oven. Set the temperature around 70/80c and leave the vial for a very good time, while shaking it during the process, (careful don't burn yourself).
When you think it's clear, heat it for a bit longer because even the tiniest crystal will make the gear crash again, as crystal formation works in a way that one crystal attracts other particles creating a multiplicative effect where it continues to create more crystals and bring the hormone out of solution again and again.
So if you heat it well once and then keep it at normal room temperature it will not crash again but if you leave even the tiniest speck in it, you will have a higher chances for it to crash again.
Many of my recipes have been tested placing the vials in the fridge at an average temperature of 2c for 48hrs and out of many vials the only one crashing were oral injectables and sometimes masteron 400mg.
Even DHB 100 didn't crash for example, tho transportation is longer than 48hrs and it's clear that in some countries it reaches well below 2 degrees.
I know it can be annoying but I believe the alternative is worse than just spending sometime heating the hormone back into solution.
It's winter time and temperatures are dropping, especially on many destinations in the north the temperatures can be challenging for the gear to stay in solution and not crash.
The thing is that especially with high concentration gear is a very fine balance between making a product with enough solvents to be smooth and stay in solution at normal temperature or overweight the solvents to make it uncrashable but that would be in my opinion a sloppy work. Anyone can just overdose the solvents part well over what's needed just to make it easy.
As I strive to offer a good balance between % of solvents and carrier oil, as I don't use EO in any standard recipes, while keeping the first at a minimum you must understand that yes some of the vials will arrive and be crashed.
Now the important part, I'll not be too technical but the thing with crashed gear and formation of crystals is this.
You need to heat it well to keep it from crashing again, so the suggestion is buy a mug warmer (10/15€ on amazon) or use your oven. Set the temperature around 70/80c and leave the vial for a very good time, while shaking it during the process, (careful don't burn yourself).
When you think it's clear, heat it for a bit longer because even the tiniest crystal will make the gear crash again, as crystal formation works in a way that one crystal attracts other particles creating a multiplicative effect where it continues to create more crystals and bring the hormone out of solution again and again.
So if you heat it well once and then keep it at normal room temperature it will not crash again but if you leave even the tiniest speck in it, you will have a higher chances for it to crash again.
Many of my recipes have been tested placing the vials in the fridge at an average temperature of 2c for 48hrs and out of many vials the only one crashing were oral injectables and sometimes masteron 400mg.
Even DHB 100 didn't crash for example, tho transportation is longer than 48hrs and it's clear that in some countries it reaches well below 2 degrees.
I know it can be annoying but I believe the alternative is worse than just spending sometime heating the hormone back into solution.
AlbanVautier
Subscriber
Has someone ever tried LGD in injectable version?
Hardcoreboy
New Member
Can you make a pre workout stack like :
50mg Test Base
50mg Tren Base
2.5mg M-Tren
or TestB/Anadrol or TestB/SuperD
50mg Test Base
50mg Tren Base
2.5mg M-Tren
or TestB/Anadrol or TestB/SuperD
Venom Lab
Subscriber
I don't have any tren base neither any mtren and to be honest I don't plan to store any for the moment.
The other two are possible
50/50 or 70/30 for test base/anadrol
TestB/superdrol it's even easier to do the split can be more or less whatever one wants it to be.
Kind regards,
Venom
Venom Lab
Subscriber
Any interest if I start stocking up BP and cholesterol and diabetic meds?
Cilnidipine 10mg 20€
Imeglemin 1000mg 25€
Jardiance 25mg x30 25€
Pitavastatin 4mg 38€
What I could offer at the moment.
Cilnidipine 10mg 20€
Imeglemin 1000mg 25€
Jardiance 25mg x30 25€
Pitavastatin 4mg 38€
What I could offer at the moment.
SwitchBlade
Member
Yes, Telmisartan for BP. Ezemitibe would also be nice.
5 stars for Venom Labs .
I ordered 5 kits gh ,bac water and 10x Test D 500 .
The communication was easy and simple ,payment simple as well . I had my goods within a Week (which is very very good )Stealth was brilliant .
Today I pinned the Test D 500 and absolutely no pip ,amazing. Just like he promised .
5/5 will definitely order again !
I ordered 5 kits gh ,bac water and 10x Test D 500 .
The communication was easy and simple ,payment simple as well . I had my goods within a Week (which is very very good )Stealth was brilliant .
Today I pinned the Test D 500 and absolutely no pip ,amazing. Just like he promised .
5/5 will definitely order again !
AlbanVautier
Subscriber
Yes totally Jardiance, Ezetimibe, Telmisartan,.. would be really nice
Venom Lab
Subscriber
The thing with ezetimihe and telmisartan is that it's readily available in 99.9% of EU countries. You just need to go to your doctor and tells him you have cholesterol issue or BP problems and you can get both fairly easy.
As it is very complicated to import pharma meds from India, and every package is a Russian roulette if it will ever arrive, I think it's more convenient for everyone to use the space in each package for meds that are too expensive or not available at all here in EU.
Like cilnidipine (not available) Imeglemin (NA) or pitavastatin and jardiance (expensive).
I'll try to see what I can do for telmi and ezetimibe. Maybe I'll be able to source it locally.
Photon
Member
Yes, you're absolutely right.
Medications like telmisartan or nevilobol are readily available in Europe.
Your doctor can prescribe them.
However, medications like cilnidipine are only approved in certain Asian countries, not in Europe or the USA.
So I completely understand your offer to provide these kinds of products, and it will always be a benefit for everyone.
Health markers like blood pressure, blood sugar, and cholesterol are the main ones to monitor when doing steroid cycles.
So, by ordering your products, anyone who needs to take certain medications like these, will be able to do so without going through another supplier.
Especially if the prices are attractive.
How many tabs is that ? Cilni and pita
AlbanVautier
Subscriber
Yes that is true, you can have it way more easily. At this price jardiance is really interesting so really nice deal from you.
Similar threads
