Hearing that warming your TEST can cut down on swelling and bumps. Should i warm up freshly drawn syringe?? Can i warm entire bottle each time? will that lessen or destroy the TEST? Thanks for any help
MESO-Rx
Anabolic Steroids
Warming TEST
- Thread starter Gatorboy
- Start date
MisterSuperGod
New Member
Warming the vial or filled syringe will allow the oil to flow faster. As far as PIP is concerned i never noticed a difference the few times i tried it.
As long as you aren't boiling the oil when heating it your Test will survive without degradation.
As long as you aren't boiling the oil when heating it your Test will survive without degradation.
OmL
Member
I submerge mine in a depth of pretty hot water that doesn’t allow the vial do float for about 9-10 minutes before using it.
theotherguy
Member
I warm my vials on a coffee mug warmer every single time I draw. This has made a huge difference for me. It is much quicker to draw into an insulin syringe and it flows much better during injection.
Be warned though, the PIP can be just as bad if you inject too fast. I have found, for me anyways, that injection speed makes the most difference with respect to PIP. I had my wife slow down with injections and I don't get PIP or swelling anymore.
And as MSG said, unless you're boiling it, you aren't going to degrade the hormone.
Be warned though, the PIP can be just as bad if you inject too fast. I have found, for me anyways, that injection speed makes the most difference with respect to PIP. I had my wife slow down with injections and I don't get PIP or swelling anymore.
And as MSG said, unless you're boiling it, you aren't going to degrade the hormone.
Jire
Member
This is the best method to warm vials and super cheap too. $15 "Mr. Coffee" warmer on Amazon works great, heats up a vial within a few minutes.
Also, after you draw, let it cool down a bit otherwise the oil gets quite hot where it hurts when you inject.
Rido
Subscriber
i personally noticed a difference. especially since I inject 3ml in less than 30 seconds. heating pad is my favorite
PrimoBowling
Banned
A pad for you Post Injection Pussies. Just a joke huehuehuehuehue Don't be mad Pee Jay
PrimoBowling
Banned
If your gear crashes then I can see how heating it up would help. Boil water in a pot at a level no higher than the vial,take it off the heat and place the vial in there. It won't destroy the gear. Part of the manufacturing process for oils involves high temp.
Now, I believe @youwhat? mentioned a method for heating up gear where he holds it between his buttocks and tries to squeeze it like a walnut. Do not do this- i cannot stress enough m that this technique is unsanitary and a quite ludicrous method of achieving results that can be accomplished much easier as I've outlined
Now, I believe @youwhat? mentioned a method for heating up gear where he holds it between his buttocks and tries to squeeze it like a walnut. Do not do this- i cannot stress enough m that this technique is unsanitary and a quite ludicrous method of achieving results that can be accomplished much easier as I've outlined
Rido
Subscriber
I wrap all my vials in there and heat It up prior to draw. I only use a heating pad for sore muscle.(not pip)
SenorSuperdrol
Member
Fellas, this is the way. Mr. Coffee coffee cup warmer. Few minutes and it heats up multiple vials easy.
It'll help a heck of a lot. I heated crashed gear and was able to not just redisolve the crystals but also draw into a slinpin. i put it right on the element on low, and used an 18g to vent the top
