Water in mast e

[Iron Vett]

Does seem like it's crashing if heat gets it into clear solution and then it falls. I don't use EO but Mast E at 18% BB and 1-2% BA works at 200mg/ml. You are at 250mg/ml. See if BB increase can salvage.

For what it's worth I see a lot of guys getting fancy going for non-standard higher concentrations or blends and messing stuff up. As a rule it seems to be the inexperienced ones. Another 50mg/ml is meaningless if you have to dump your batch. Just go with a standard recipe that everyone knows holds perfectly, hot plate w/ stirrer, preferably bottle top filter to media bottle...voila.

Personally I don’t find that big of a difference in solubility with eo if your already using mct as a carrier. I’ve begun to use eo only in brews that I feel will have considerable injection pain since it has a bit of an anesthetizing effect. But I do agree with you in these higher compound brews being a bit more difficult at times. All of my recipes are the old standard concentrations except for Deca. I’ve started brewing Deca at 300

 

[AASraw]

This is a case from our client.

He brewed some oil and it turned cloudy after cool down. Then, ask me why it happened. After talking with some other friends and found moisture inside the oil. So, let him to heat it and yes, it turned to clear. But, after a night, it was cloudy again.

Later on, to check his picture, we found he heated the vials without turning the cap off. So, as you know, the key reason turned out. No steam can got of the vials. That caused the oil cloudy again.

Just a funny story and it could be helpful for anyone, who needs to be more careful on the specifics.

 

[Avatar1338]

what you can do is to add alcohol (96%) to your mix and let it sit till the alcohol evaporates with the moisture thats inside. you can add low heat or wait a few days, than refilter it. i have tried this with cloudy eq and it worked. in my case, the eq itself contained moisture. just make sure that all the alcohol has evaporated, otherwhise it will burn while injecting.

 

[Grandpa Gainz]

Now that you’ve posted your recipe, I think it’s crashing. 10%BB is pretty low for 250mg/ml. You can try adding another 5-10%BB or else just heat it before every injection.

Right. If it was water it wouldn’t clear with heat. Correct? I had moisture and it didn’t clear until I brewed it at 250 for like 30 minutes. Pia. Probably degraded some.