TrNE problems

[Infidel141]

Any positive change?

I heated again on low and stirred for about 45minutes, all dissolved. I went ahead and filtered into media some media bottles, and it held up for about 2 days one of them started to crash. Not much but still...

The other bottle didnt get any Crystal's in it, but when you turn the vial upside down theres like a yellow tint stuck to the bottom until I shake it up.

 

[ickyrica]

I heated again on low and stirred for about 45minutes, all dissolved. I went ahead and filtered into media some media bottles, and it held up for about 2 days one of them started to crash. Not much but still...

The other bottle didnt get any Crystal's in it, but when you turn the vial upside down theres like a yellow tint stuck to the bottom until I shake it up.

I've also had that yellow tint, almost like fine powder on the bottom? No clue where it comes.from. I pinned it and was fine but im not recommending that to anyone. Im just a weirdo lol.

You can always add a small percentage of filtered BB and if it's that close sounds like it would hold. If I was to add.more it would be 1%

 

[Infidel141]

What makes that happen? (One bottle crash) even though they're the same batch? I had that happen with prop too. One of them crashed and the other is just fine

 

[ickyrica]

Normally I would answer that by saying it wasn't blended thoroughly but it sounds like you took it to task.

The only other reason I can give you would be that some variable has changed. I switched mct brands at one point and what I found was all of my test cyp that's using the new carrier oil crashes in the winter and falls back in during the summer. The older carrier never crashes. Same ratios, raws etc. But I realize that this is also not the case with your situation.

I'm at a loss man.