Titanium Gear Industries (domestic source)

[bolder]

Hell, idk. Here’s these: https://www.drugsupplystore.com/products/monoject-softpack-insulin-syringes-1-cc-ml-x-28-g-1-2-100-ct.html

In light of new information brought forth by @The Terminator pins are no longer needed. Only the syringe for anal administrations
Let us know how it works!!

 

[Jrock83]

I followed your suggestion above and DHB stays in the solution completely at least for 15hours. The only mistake I made was that temp was around 275 for only a few minutes at the very beginning of the process and black snapoffs tops started to deform and I quickly took the vials out and removed the snapoffs. Because TGI fills the vials to the top (which we like!) and expansion of the liquid at hot temps, some oil leaked oil of vials. Then i set the temp back to 200, put the vials back in for about 1.5hours during which time I shook the vials vigorously every 10mins.
@Jrock83 , @bolder @Urgentfury12 , @TitaniumGear (TGI) , Do you guys think I should filter the oil given that the vials were at high temp of about 275 for a few minutes, in case particles from the rubber cap or plastic snapoffs leached in the solution?

I doubt that there was any leaching, but I cannot say for sure. I apologize for not being as thorough as I should have been while giving you that advice. For future reference, anytime you are going to use this method to bring oil into solution, ESPECIALLY if the vials are full, you need to vent the vial. This can be done by taking a syringe tip and pushing it into the vial. This will release any built up pressure inside at high temps. I think for peace of mind for the both of us, filtering the gear again would definitely not hurt, but like I said before, I cant imagine that it would leach. Maybe someone will chime in here that you have tagged as well. @Roger rabbit is also very knowledgable in this are too

 

[bolder]

I followed your suggestion above and DHB stays in the solution completely at least for 15hours. The only mistake I made was that temp was around 275 for only a few minutes at the very beginning of the process and black snapoffs tops started to deform and I quickly took the vials out and removed the snapoffs. Because TGI fills the vials to the top (which we like!) and expansion of the liquid at hot temps, some oil leaked oil of vials. Then i set the temp back to 200, put the vials back in for about 1.5hours during which time I shook the vials vigorously every 10mins.
@Jrock83 , @bolder @Urgentfury12 , @TitaniumGear (TGI) , Do you guys think I should filter the oil given that the vials were at high temp of about 275 for a few minutes, in case particles from the rubber cap or plastic snapoffs leached in the solution?

If you put a vial in the oven always take the plastic tops off and vent the vial with a needle by unscrewing the needle from the syringe and stick it in top of the rubber stopper.
Definitely inspect each vial. Use your phones flashlight and set the vial on top where the light shines through the vial. If you feel uncomfortable about it just go ahead and filter the oil into a sterile vial. That will rule out any doubt and you will know 100% that it’s sterile by doing so. Always better to be safe than sorry!

 

[Kpaxi]

And how old is this friend might I ask ?

Early thirties

 

[T-Bagger]

You have 19 vials of Test E??? I currently have 16 plus the one I’m currently using. You will sell out of that when the noobs play the “crash test dummy” routine.

And anyone can price their product really really low if they don’t currently have it.

I think you underestimated the amount of business you COULD get here (if you survive the vetting process). You might want to stop now, go away and come back in a couple years. You’re in over your head already.

Not gonna lie its not a bad intro... But that stock man... You would be shutting down a lot unless you can keep those numbers up. Is the mig only for viscosity reasons? No increase in concentration?

Only one deliberate shut down and that was because he wanted a break, not to reup. Never had to wait a few years and come back. Good job Titter - you started as an underdog and became leader of the pack, setting the standard for what a UGL should be here. And yet people still buy from other untested UGL’s. I can’t fathom it.

Side note - not giving either of you two crap, just funny to revisit the beginning of the phenomenon known as “Titter’s Place.”

 

[T-Bagger]

In light of new information brought forth by @The Terminator pins are no longer needed. Only the syringe for anal administrations
Let us know how it works!!

His suggestion, his practice, not mine lol.

 

[HIGHRISK]

Not the rich. The elite. Excuse me.

Thank you leave us out this

 

[HIGHRISK]

Nope. Said it 100 times now. I will add one more oral blend and primo eventually. Thats it. Forever.

Was this comment 100 making this one 101 or did you mean 99 prior to this one?

 

[BigBaldBeardGuy]

Was this comment 100 making this one 101 or did you mean 99 prior to this one?

Lol. Smart ass.

 

[Heavy Iron]

Only one deliberate shut down and that was because he wanted a break, not to reup. Never had to wait a few years and come back. Good job Titter - you started as an underdog and became leader of the pack, setting the standard for what a UGL should be here. And yet people still buy from other untested UGL’s. I can’t fathom it.

Side note - not giving either of you two crap, just funny to revisit the beginning of the phenomenon known as “Titter’s Place.”

Definitely kept those numbers up! Solid list too.

 

[TitaniumGear (TGI)]

I followed your suggestion above and DHB stays in the solution completely at least for 15hours. The only mistake I made was that temp was around 275 for only a few minutes at the very beginning of the process and black snapoffs tops started to deform and I quickly took the vials out and removed the snapoffs. Because TGI fills the vials to the top (which we like!) and expansion of the liquid at hot temps, some oil leaked oil of vials. Then i set the temp back to 200, put the vials back in for about 1.5hours during which time I shook the vials vigorously every 10mins.
@Jrock83 , @bolder @Urgentfury12 , @TitaniumGear (TGI) , Do you guys think I should filter the oil given that the vials were at high temp of about 275 for a few minutes, in case particles from the rubber cap or plastic snapoffs leached in the solution?

I would be afraid at 275 the rubber being butyl treated contaminating the mix...but not sure.

Only one deliberate shut down and that was because he wanted a break, not to reup. Never had to wait a few years and come back. Good job Titter - you started as an underdog and became leader of the pack, setting the standard for what a UGL should be here. And yet people still buy from other untested UGL’s. I can’t fathom it.

Side note - not giving either of you two crap, just funny to revisit the beginning of the phenomenon known as “Titter’s Place.”

19 vials...supplier was late...mom was gonna kick me out of the basement...lmao. sorry for the shit stock levels in the beginning. And thanks to all those day 1 mother fukkahs that gave me the shot to prove i would do what i said.

Was this comment 100 making this one 101 or did you mean 99 prior to this one?

You sir, are a bit of a dick.

Definitely kept those numbers up! Solid list too.

i did it for you man!

 

[HIGHRISK]

Lol. Smart ass.

I just wanted to make sure we are all on the same page

I would be afraid at 275 the rubber being butyl treated contaminating the mix...but not sure.
19 vials...supplier was late...mom was gonna kick me out of the basement...lmao. sorry for the shit stock levels in the beginning. And thanks to all those day 1 mother fukkahs that gave me the shot to prove i would do what i said.


You sir, are a bit of a dick.
i did it for you man!

Coming from you sir I’ll take that as a compliment

 

[bolder]

Only one deliberate shut down and that was because he wanted a break, not to reup. Never had to wait a few years and come back. Good job Titter - you started as an underdog and became leader of the pack, setting the standard for what a UGL should be here. And yet people still buy from other untested UGL’s. I can’t fathom it.

Side note - not giving either of you two crap, just funny to revisit the beginning of the phenomenon known as “Titter’s Place.”

I was also on the “wtf” bandwagon especially on stock levels lol. @TitaniumGear (TGI) has keep his ear open to the members here and took constructive criticism and rolled with it and not against it. This is what has helped him grow, along with his work ethic and setting goals out in the open and striving to meet those goals. Now he just has to keep it up!
But these are the reasons I believe that has brought him success so far and has him wagging his tail all the way to the bank!

 

[Dissident]

Can't say I've been here since his first post, but I got in early when I discovered Meso after lurking on other TRT boards...This has been the strangest forum thread that I've ever seen. But its been fun, informative and downright productive. I think TGI's "storefront" on Meso is a valuable resource for this community (if you can handle the chaos). So many hidden gems along the way. Thanks everyone - you too TGI. Solid stuff so far.

 

[Thegreek]

Shit never thought of amazon for that lol thanks brother

Healthykin for syringes

 

[TitaniumGear (TGI)]

I was also on the “wtf” bandwagon especially on stock levels lol. @TitaniumGear (TGI) has keep his ear open to the members here and took constructive criticism and rolled with it and not against it. This is what has helped him grow, along with his work ethic and setting goals out in the open and striving to meet those goals. Now he just has to keep it up!
But these are the reasons I believe that has brought him success so far and has him wagging his tail all the way to the bank!

not the bank. It goes back into the business. Give me time and i will show you what i mean.

Can't say I've been here since his first post, but I got in early when I discovered Meso after lurking on other TRT boards...This has been the strangest forum thread that I've ever seen. But its been fun, informative and downright productive. I think TGI's "storefront" on Meso is a valuable resource for this community (if you can handle the chaos). So many hidden gems along the way. Thanks everyone - you too TGI. Solid stuff so far.

Thank you. Been a tough trip these last few months. But here we are.

 

[Thegreek]

Whats wrong with healthy kin dot com? They ship fast af and have a huge selection and cheap. I get 500 at a time.

Bro I’ve just brought that up and have mentioned it a few times. No one listens.

 

[bolder]

not the bank. It goes back into the business. Give me time and i will show you what i mean.

Subbed

 

[TitaniumGear (TGI)]

Subbed

Gonna be some shit like you never seen before. But I need a couple/few months.

 

[BigBaldBeardGuy]

Gonna be some shit like you never seen before. But I need a couple/few months.

Fuck yea! The anabolic revolution is finally here!