Anadrol caps

[Holidaypay]

Ok so I'm gna cap some a bombs I just wana make sure I gt this right before I start
Step 1: fill cap with filler an pack down
Step 2: dump out cap an weigh filler
Step:3 minus active ingrediant from filler an mix raw an filler
Step 4:cap them butches
Step 5:eat A-bombs till I bleed from eyes

Seems pretty straight forward but just wanted to check before I mess around with 5 grams of anadrol I'm gna do 100 caps at .50 mg a piece so 5 grams would be my active total correct? I know solutions are easier but I wana make some caps to get the process down pact

Appreciate any advise except masterons fuck masteron

 

[Holidaypay]

On a side note has anyone had anadrol that's like a real fluffy flower like consistency most oral raws that I have seen are more granular like salt or sugar I know it doesn't mean much but I'm curious if its out of the norm thanks

 

[T-Bagger]

On a side note has anyone had anadrol that's like a real fluffy flower like consistency most oral raws that I have seen are more granular like salt or sugar I know it doesn't mean much but I'm curious if its out of the norm thanks

Anadrol definitely has a funky texture to it

 

[Iron Vett]

Ok so I'm gna cap some a bombs I just wana make sure I gt this right before I start
Step 1: fill cap with filler an pack down
Step 2: dump out cap an weigh filler
Step:3 minus active ingrediant from filler an mix raw an filler
Step 4:cap them butches
Step 5:eat A-bombs till I bleed from eyes

Seems pretty straight forward but just wanted to check before I mess around with 5 grams of anadrol I'm gna do 100 caps at .50 mg a piece so 5 grams would be my active total correct? I know solutions are easier but I wana make some caps to get the process down pact

Appreciate any advise except masterons fuck masteron

I just posted the following in another thread.



I completely filled and packed one of my 0 sized capsules with baking soda and weighed it. Then weighed an empty one. Substracted and found the capsule held 850mg of baking soda. That times 100 capsules is 85 grams. Subtract the total compound from that (ex. 5 grams Anavarto make 50mg caps) and you mix up 5 grams anavar and 80 grams baking soda. Fill your caps and adjust filler up or down till you mix fills exactly 200 caps.

 

[T-Bagger]

I just posted the following in another thread.



I completely filled and packed one of my 0 sized capsules with baking soda and weighed it. Then weighed an empty one. Substracted and found the capsule held 850mg of baking soda. That times 100 capsules is 85 grams. Subtract the total compound from that (ex. 5 grams Anavarto make 50mg caps) and you mix up 5 grams anavar and 80 grams baking soda. Fill your caps and adjust filler up or down till you mix fills exactly 200 caps.

Who the hell wants to do all that math?

 

[Iron Vett]

Who the hell wants to do all that math?

No doubt lmao. We need a spoon feeding emoji hehe

 

[Holidaypay]

I just posted the following in another thread.



I completely filled and packed one of my 0 sized capsules with baking soda and weighed it. Then weighed an empty one. Substracted and found the capsule held 850mg of baking soda. That times 100 capsules is 85 grams. Subtract the total compound from that (ex. 5 grams Anavarto make 50mg caps) and you mix up 5 grams anavar and 80 grams baking soda. Fill your caps and adjust filler up or down till you mix fills exactly 200 caps.

Thanks that's what I'm using to I'm making 100 2 an it seems simple just sounds hard when reading it maybe that's me tho its always easier to learn something when I see it instead of when I read it

 

[TideGear]

Ok so I'm gna cap some a bombs I just wana make sure I gt this right before I start
Step 1: fill cap with filler an pack down
Step 2: dump out cap an weigh filler
Step:3 minus active ingrediant from filler an mix raw an filler
Step 4:cap them butches
Step 5:eat A-bombs till I bleed from eyes

Seems pretty straight forward but just wanted to check before I mess around with 5 grams of anadrol I'm gna do 100 caps at .50 mg a piece so 5 grams would be my active total correct? I know solutions are easier but I wana make some caps to get the process down pact

Appreciate any advise except masterons fuck masteron

How To Cap Powders Accurately

Learn this method and never look back. Get size 3 caps, nothing bigger. The reason for this is that the smaller the cap, the less filler you need. The less filler used, less time mixing. Keep a note pad for each compound and you'll always have a formula and you can skip a few steps in the future. Don't half ass it and thank me later.

 

[Iron Vett]

How To Cap Powders Accurately

Learn this method and never look back. Get size 3 caps, nothing bigger. The reason for this is that the smaller the cap, the less filler you need. The less filler used, less time mixing. Keep a note pad for each compound and you'll always have a formula and you can skip a few steps in the future. Don't half ass it and thank me later.

I use size zero because my fingers have too much trouble holding those little caps lol

 

[TideGear]

I use size zero because my fingers have too much trouble holding those little caps lol

I feel ya. I used 1's for a while but I could only make 150 caps in 1.5 hours. I went to 3's and I can mix much faster now.

 

[The ole man]

I’m gonna imagine that making anavar caps is the exact same process?
Adex?

 

[T-Bagger]

I’m gonna imagine that making anavar caps is the exact same process?
Adex?

With the exception of mcg based compounds, yes. All caps are the same process.

 

[TideGear]

I’m gonna imagine that making anavar caps is the exact same process?
Adex?

With var or any granular compound, I like to grind them as close to fine powder as possible before anything else. After that it's the same process.

 

[The ole man]

With the exception of mcg based compounds, yes. All caps are the same process.

With var or any granular compound, I like to grind them as close to fine powder as possible before anything else. After that it's the same process.

Appreciate it. Ya I’m gonna say the ole mini coffee grinder would do the job.
I would like to cap some var, and brew some sust moving forward.
So I’ve been reading and following all these threads. Like a mini college course so much to learn.
In some aspects it’s seems rather easy, But the sterilization and filtering, along with the mathematical computations, most definitely make you question yourself.

 

[T-Bagger]

Appreciate it. Ya I’m gonna say the ole mini coffee grinder would do the job.
I would like to cap some var, and brew some sust moving forward.
So I’ve been reading and following all these threads. Like a mini college course so much to learn.
In some aspects it’s seems rather easy, But the sterilization and filtering, along with the mathematical computations, most definitely make you question yourself.

I always thought all you had to do was throw some compound in a cap and be done. With those super small caps, I’m sure you could do it that way.

 

[The ole man]

I always thought all you had to do was throw some compound in a cap and be done. With those super small caps, I’m sure you could do it that way.

Right, because all your really doing is putting the compound in, and then filling the rest with filler, if there is room for filler. So smaller would mean less filler?
I got digitals and it goes down to the 10th of the gram, so I’m thinking it shouldn’t be hard.

 

[The ole man]

How To Cap Powders Accurately

Learn this method and never look back. Get size 3 caps, nothing bigger. The reason for this is that the smaller the cap, the less filler you need. The less filler used, less time mixing. Keep a note pad for each compound and you'll always have a formula and you can skip a few steps in the future. Don't half ass it and thank me later.

Awesome link!
I saved it for future reference!

 

[LeoTC]

Honestly, if you don't need to make them pretty for resale, why bother with a filler at all?

I might be missing something, I guess. But you're just capping the shit for ease of use.

 

[Iron Vett]

Right, because all your really doing is putting the compound in, and then filling the rest with filler, if there is room for filler. So smaller would mean less filler?
I got digitals and it goes down to the 10th of the gram, so I’m thinking it shouldn’t be hard.

You need to go back and read my post and the link that @TideGear posted again. You are not weighing out each individual dose and then adding filler. You are mixing an entire batch to fill a certain number of caps at one time so you don’t have to measure out hundreds of tiny doses

 

[The ole man]

You need to go back and read my post and the link that @tide

I’m actually reading right now.
I see the math that shows the breakdown. And if you were making tablets, then most deff would have to do that. But 50 mg of a compound in a capsule, with or without filler, is still gonna be 50 mg of a compound.
This would be for personal consumption.

Maybe I’m missing something???