MESO-Rx

Anabolic Steroids

Oral steroids in oil (injectable)

P

Petarosus188

Member
Hello,
Id like to ask for opinions and feedback on orals (oxymetholone, oxandrolone...) in injectable OIL. To my understanding- steroids without ester are highly fat solluble....steroids will dissolve in oil rapidly... I thought thats why it used to be put in water (TNE as well). As a little evidence- when pharmacom injectable oxymetholone was tested...in couple months it had 15%+ oxymetholone GONNE.
What is you opinion and experience? Id like to get injectable anadrol, but as far as I know...it would have very short shelf-life..and sources in here wont send you injectable one...thats maximum one month old...
 
Petarosus188 said:
Besides multiple pros recommending (Fritz and fuck even Piana), longer half-life and possibly less stomach irritation (I dont suffer from that too much anyway)
Click to expand...

most of the pros that used to promote injectable preparations of oral compounds did so believing that they were avoiding the liver stress by doing so, so their recommendations aren't exactly valid. (not that drug advice from pros is historically great to begin with)

There really isnt much reason to use injectable preparations of orally bioavailable compounds in my opinion (especially if you dont get the gut issues from orals) other than mainly doing so to leverage the faster peak time.

its just more pinning and usually bad pip for no real benefit in my book
 
BigTomJ said:
most of the pros that used to promote injectable preparations of oral compounds did so believing that they were avoiding the liver stress by doing so, so their recommendations aren't exactly valid. (not that drug advice from pros is historically great to begin with)

There really isnt much reason to use injectable preparations of orally bioavailable compounds in my opinion (especially if you dont get the gut issues from orals) other than mainly doing so to leverage the faster peak time.

its just more pinning and usually bad pip for no real benefit in my book
Click to expand...
Honestly I expect to agree with you, but after like 5 years of hearing "injectable anadrooll!!!" last being Roman Fritz with Chase...I encountered source that has it (normally its not availiable in Czech Republic)....but I remember that test of Pharmacom....and also why would steroids be put in water then (when they are ester-less)? Injectable winnie hurts like fucking hell.
 
Petarosus188 said:
Honestly I expect to agree with you, but after like 5 years of hearing "injectable anadrooll!!!" last being Roman Fritz with Chase...I encountered source that has it (normally its not availiable in Czech Republic)....but I remember that test of Pharmacom....and also why would steroids be put in water then (when they are ester-less)? Injectable winnie hurts like fucking hell.
Click to expand...
i think people like injectable anadrol because anadrol is one of those steroids that you can really "feel" and with the faster peek times with injectable preparations people just really feel it and associate that feeling with efficacy.

as far as the preparation process, i dont know enough to speculate why they would use oil vs aqueous mediums with injectable orals.
 
micro2000 said:
Some are very soluble while some are not. The chain length of the ester adds to solubility. Unesterified steroids tend to have low solubility.
Click to expand...
So in other words, we could expect stability of orals in oil? And all these suspensions in water are in water...just so they work "faster"? Thats what you are saying?
 
Petarosus188 said:
So in other words, we could expect stability of orals in oil? And all these suspensions in water are in water...just so they work "faster"? Thats what you are saying?
Click to expand...
I'm not sure I understand your questions. Suspensions aren't immediate release. The crystals have to dissolve to enter the blood stream and being that the steroid is hydrophobic and in an aqueous environment (tissues), this is not an immediate process.

It's easier to make a suspension at higher concentrations cause you are just mixing solids in water. The downside is considerable tissue irritation which prevents people wanting to use it. Actually dissolving steroid bases like stanazolol in high concentrations is harder and requires extra solvents.
 
micro2000 said:
I'm not sure I understand your questions. Suspensions aren't immediate release. The crystals have to dissolve to enter the blood stream and being that the steroid is hydrophobic and in an aqueous environment (tissues), this is not an immediate process.

It's easier to make a suspension at higher concentrations cause you are just mixing solids in water. The downside is considerable tissue irritation which prevents people wanting to use it. Actually dissolving steroid bases like stanazolol in high concentrations is harder and requires extra solvents.
Click to expand...
Original question was about oxymetholone molecule basically breaking down in oils..
 
I love my Injectable Winnie in oil. I’ve never had any pip. I don’t have the blood work issue most get w Winnie so I love it. I’ve never tried anadrol. I would go on the home brew section. I’m sure there are plenty of posts on how to do it
 
You must log in or register to reply here.

Similar threads

Annie55
China LFP Factory (Peptides, Steroids, Sarms) Ship to USA, UK, Spain, Netherlands...
13 14 15
Replies
281
Views
55K
djedo
D
TheScholarOfBrew
Save your unusable raws Guaranteed.
19 20 21
Replies
418
Views
17K
Motojager
Motojager
Primal_Pharma
  • Sticky
MESO-Rx Sponsor Primal Pharma - US Domestic
823 824 825
Replies
16K
Views
871K
darkdays
darkdays
Musmadar
Future Project: Brewing Injectable Oxandrolone -Seeking Community Input-
2 3
Replies
44
Views
2K
Jaxino
J
D
back from the dead
2
Replies
21
Views
1K
mikeh1998
mikeh1998

Sponsors

Latest posts

Back
Top