TheScholarOfBrew
Banned
I started this project with the goal of purifying trenbolone acetate into large, high-purity crystals that can serve as a visual and chemical indicator of quality—ideally 98% purity or higher. The following is a chronological summary of the steps I’ve taken so far:
1. Initial Material
I began with trenbolone acetate in powder form. It appeared to have minimal binders or fillers, as it readily dissolved in acetone with no obvious residue.
2. Solvent Preparation
I used store-bought acetone as my solvent. Because water content interferes with crystallization, I dried the acetone using magnesium sulfate. The drying was confirmed by lack of water layering and improved clarity.
3. Dissolution Phase
I heated the dried acetone and added the trenbolone acetate powder until fully dissolved. I used a beaker and heated it using a hot plate until the solution was saturated and clear.
4. Filtration
I did A hot filter pass using my vacuum filtration unit, and for future authorization, I did oxidize some of the tren due to light exposure. So for future reference, it's best to do this in a dark environment, or at least without sun exposure and minimal exposure to other contaminants.
This can be completely avoided using lower temps. However, the crystals I recovered are not oxidized as indicated by the color, light, canary yellow.
5. Crystallization
I covered the beaker and placed it Too cool to room temp. It took two hours. Then I transferred to the fridge for a few more hours. covered with aluminum foil. Then transferred back into the freezer and left it there overnight (approximately 7 hours). When I checked it the next day, large, slow-forming hexagonal crystals had begun forming at the bottom.
6. Post-Crystallization Observation
The crystallization process was slow and steady, which is a good sign—slower growth tends to yield purer, more defined crystals. The acetone above the crystals had turned orange to red, indicating that oxidation products and impurities had been excluded from the lattice and left behind in the mother liquor.
7. Next Steps
I’ll let it sit for another 24 hours in the fridge to allow further slow growth. After that, I will perform another filtration to remove the solvent and oxidized byproducts. Then I will dry the crystals completely (likely air drying or fan drying in a clean area) and weigh them to determine recovery and yield.
The size and structure of the crystals so far suggest a high-purity final product. This method, using nothing but dried acetone, Confirmed, pure, or without many contaminants based on the material safety data sheet of the acetone brand I use. patience, and temperature control, proves that achieving pharmaceutical-grade crystal clarity is very possible with simple tools.
Further updates coming soon.
Scientific Context:
Trenbolone acetate’s optimal recrystallization occurs when the solvent system is carefully saturated and then cooled gradually to encourage orderly lattice formation. These large, distinct crystals suggest minimal nucleation sites, a sign of high-purity isolation. Disordered growth or needle-like aggregates typically signify rapid precipitation or contamination.
This result is a clear proof of concept that high-grade purification of hormone powders is achievable using fundamental organic chemistry methods and basic lab infrastructure when controlled precisely.
Last edited:
