Photon
Member
Even female progesterone injections use 10%.
I use 10% too in my TNE with no PIP.
MESO-Rx
Anabolic Steroids
Test E Homebrew Question - Is 2% BB Sufficient for Stability?
- Thread starter AlhambraGB
- Start date
Even female progesterone injections use 10%.
I use 10% too in my TNE with no PIP.
I assure you no one home brewing sustanon is using 10% BA and if they do I promise you they won’t take more than one shot of that stuff.
SUSTANON 250 250MG/ML SOLUTION FOR INJECTION | Drugs.com
Patient information for SUSTANON 250 250MG/ML SOLUTION FOR INJECTION Including dosage instructions and possible side effects.www.drugs.com
Educate yourself
The average usage date of benzyl alcohol in injectable pharmaceuticals is from 0.5-2.0%.
Photon
Member
Tell that to the females who pin 10% b.a progesterone routinely.
Spaceman Spiff
Subscriber
That wasn't what the discussion was but you don't seem to be families of the pharma recipes
Why should I be, they’re junk and unnecessary by all means. It isn’t any indication of the real world of hormones we use.
That’s facts whether you like that or not. You are buying pharmaceutical grade sustanon with 10% BA over UG stuff so how does that pertain to anything we discuss in the “Steroid Homebrew” message forum.
The fact is you are wrong, BA content has EVERYTHING to do with PIP! It is a guaranteed FACT that 10% BA content will have excessively more PIP than a brew with 2% BA.
Spaceman Spiff
Subscriber
I use 10% BA in test no ester and I get no pip whatsoever. Maybe the guaranteed fact is that you’re just a pussy.
Or just not “guaranteed dumb” enough to use 5X the amount of BA required to make a batch of test!
To each their own!
Photon
Member
Does yours crash?
I'm using lesser BB than you and at a higher concentration.
Mine starts forming really pretty crystals ~day 5.
AlhambraGB
New Member
Planning on brewing that next with 2/20
If you try 100mg/ml, hope you like crystals. It won’t hold long unless you do 10% BA or use guaiacol.
Are you making in oil or a water base?
Photon
Member
What would 2/20 represent in a water base?
Do people actually use BA/BB in a water base?
AlhambraGB
New Member
Oil base, never done water base before. Which one is better?
No I haven’t had it crash yet. In solution for months at this point.
I have brewed a few hormones with only MCT oil / 1.5% BA (no benzoate). Test C, test E, deca, and boldenone.
Everyone has their preference, but if I can adjust the concentration to eliminate the solvents I think it's better. I am not 100% sure that the BB I get is really pharma grade despite the seller claims. I do use it for some things...
Everyone has their preference, but if I can adjust the concentration to eliminate the solvents I think it's better. I am not 100% sure that the BB I get is really pharma grade despite the seller claims. I do use it for some things...
can you share your recipes? have you tried masteron or primabolan without BB
I would have expected this to cause a lot of pip
My thinking on PIP is that it is caused by too much benzyl alcohol, too high a product concentration, or undissolved solids in the oil. Is that correct?
My limited experience is that a fully dissolved product in MCT carrier oil without solvent causes no PIP at all (1.5% BA).
