Chinese oils crashed assistance

[defqon1]

Hey boys
I purchased this 10 pack of Test Cyp 300 from a Chinese vendor and about 5 of the vials are crashed..even tried boiling water etc they are still coming out of suspension hours later, for any experienced brewers i was wondering if there is anything I can add to the oil to keep it hold or are they worth just binning? Dissapointing its come to this in the current market ! Many thanks

 

[jung]

I'll let someone more experienced speak into it, but I would just add some benzyl benzoate to start with to help it hold. Stair-step up the BB, waiting a bit and stirring it occasionally between each addition of BB to the vial until it holds and then make note of what you need to add to the other vials.

Unless you have a Jano test for it, you can assume the real concentration is 300mg/ml and then use ChatGPT to help calculate your dosing based on how much BB you add.

 

[Ghoul]

Try sticking a sealed vial in the middle of an oven and bake at 165-170f (usually the minimum temp), for 45 minutes. No, the plastic and rubber won't melt at that temp.

I find it keeps constantly recrashing vials in solution for good.

I think it may be because other methods don't always fully melt the crystallized gear, and if there's even a tiny speck left, it acts as a "seed" for faster crashing.

 

[Trenbolonetax]

@walterhype

 

[defqon1]

Thanks guys, ive heard a few guys throw around EO..I've never heard of it but reckon it would be the cause, I believe the HPLC from Jano was about 313mg/ml

 

[BigDadd7]

Do the oven method before you go adding crap to it. I use my coffee cup warmer set at 180 for an hour.

 

[defqon1]

 

[Photon]

Thanks guys, ive heard a few guys throw around EO..I've never heard of it but reckon it would be the cause, I believe the HPLC from Jano was about 313mg/ml

No it's not the cause.

His gear looks horrendous.
It almost looks like there's no oil or BB in it.

I don't think heating is going to save it. What your ambient temperature at?

 

[Spaceman Spiff]

Get a coffee mug warmer .. don't put it in the oven, that's retarded

 

[defqon1]

No it's not the cause.

His gear looks horrendous.
It almost looks like there's no oil or BB in it.

I don't think heating is going to save it. What your ambient temperature at?

About 16 degrees at night/23 degrees roughly in the day..i agree I dont understand how they can fuck up something like Test, ive seem better results people homebrewing proviron lol

 

[dick_starbuck]

No it's not the cause.

His gear looks horrendous.
It almost looks like there's no oil or BB in it.

I don't think heating is going to save it. What your ambient temperature at?

It appears to be JY test cyp 300. It has BB and EO, allegedly, its just very over dosed.

 

[Ghoul]

Get a coffee mug warmer .. don't put it in the oven, that's retarded

It works jackass.

 

[dick_starbuck]

It works jackass.

Id still opt for the coffee mug warmer. They get to 170 degrees and you have the piece of mind of being able to readily see how the process is unfolding.

 

[Spaceman Spiff]

It works jackass.

no shit, its still dumb as fuck, just like you.


coffee warmer is a much better option to keep it at 130 degree F

You spend so much time on chat GPT you have no common sense.

 

[Spaceman Spiff]

I find it keeps constantly recrashing vials in solution for good.

this is when you need to stfu and not give advice. you know that its heated that time when people brew it? why did it crash

You have no idea about brewing. The product needs more solvents to not recrash.

You cannot use information you gather properly. You are a nitwit

 

[knucklesamich]

OP-

Do you have a glass top stove? These work so well in an actual home brew, but they work to bring back a crashed brew as well. Very low heat, otherwise when my Test Cyp 300 crashes, I do as a lot of others are specifying, use a mug warmer.

If my gal is around, I don't use my stove for these things, I don't get her involved in anyway. Gives her plausible deniability (I think that's the proper term) if anything should ever happen. When she's home with me, and I need to do this, I use the mug warmer that sits in a little hidden spot she never would go.

It'll eventually crash again, probably. 300 mg/ml is pretty potent for Test Cyp, so, just bring it back. Plus if you do this just before pinning, it's going to be nice and thin.

 

[knucklesamich]

I'll let someone more experienced speak into it, but I would just add some benzyl benzoate to start with to help it hold. Stair-step up the BB, waiting a bit and stirring it occasionally between each addition of BB to the vial until it holds and then make note of what you need to add to the other vials.

Unless you have a Jano test for it, you can assume the real concentration is 300mg/ml and then use ChatGPT to help calculate your dosing based on how much BB you add.

This isn't a bad idea either, if you REALLY want to keep it from crashing. If you brew 300mg/ml and you're making enough to put into a 10 ml vial, you're using 3 grams of Test Cyp powder.

If you add 2 ml of BB to one of these little vials, assuming it has the volume to accommodate, you'll have a total of 12 ml. It'll bring the potency down to 250 mg/ml. That would do it. It's some work for OP, but doable if you have the stuff to do it. I'm lazy though, I just heat it up

 

[niqTM]

This isn't a bad idea either, if you REALLY want to keep it from crashing. If you brew 300mg/ml and you're making enough to put into a 10 ml vial, you're using 3 grams of Test Cyp powder.

If you add 2 ml of BB to one of these little vials, assuming it has the volume to accommodate, you'll have a total of 12 ml. It'll bring the potency down to 250 mg/ml. That would do it. It's some work for OP, but doable if you have the stuff to do it. I'm lazy though, I just heat it up

I think the BB idea is the best idea to fix it. Obviously you can heat it up every time you use it but adding 2ml if BB should fix it permanatly. Worth a shot in one of the vials just to see.

 

[BigDadd7]

...
If my gal is around, I don't use my stove for these things, I don't get her involved in anyway. Gives her plausible deniability (I think that's the proper term) if anything should ever happen. When she's home with me, and I need to do this, I use the mug warmer that sits in a little hidden spot she never would go....

I really thought you were going to say you tucked it between her butt cheeks.

 

[knucklesamich]

That's a hell of a spot right there, I bet would bring a crashed brew back into solution