Wuhan Wansheng Biotechnology Co., Ltd. (USA, International)

I cut it with half 100mg/mL primo to dilute it because I assumed the 200mg/mL would have pip on its own.

Still had a lot of pip

maybe when I cut it with test it’ll be better. I did a big primo only shot to front load.
you need to try mix primo 200mg with other compund in your cycle , EQ is great , or mast , when i mix compound my pip is zero
 
I cut it with half 100mg/mL primo to dilute it because I assumed the 200mg/mL would have pip on its own.

Still had a lot of pip

maybe when I cut it with test it’ll be better. I did a big primo only shot to front load.
Try the 100mg and 200mg variants separately. For some reason, I get PIP with the 100mg/ml, but the 200mg/ml is completely pipless. It could be due to the solvents or something else at play.

My 100mg/ml from Dutch Labs gives me PIP, while the 200mg/ml from China does not. (The 200mg version has EO, which makes it much easier to push, and since my body tolerates EO well, I prefer CN oils and have no issues with higher concentrations.)
 
Try the 100mg and 200mg variants separately. For some reason, I get PIP with the 100mg/ml, but the 200mg/ml is completely pipless. It could be due to the solvents or something else at play.

My 100mg/ml from Dutch Labs gives me PIP, while the 200mg/ml from China does not. (The 200mg version has EO, which makes it much easier to push, and since my body tolerates EO well, I prefer CN oils and have no issues with higher concentrations.)
I did the following 3mL shot yesterday

.5mL primo 200 wwb
1mL primo 100 wwb
1.5mL test cyp 250 wwwb

So far no issues, but usually takes 2-3 days for pip to peak if there is any.
 
Curious how they came out?
I tanked my shgb so my labs were lower than I was expecting. I sent the test C to jano to confirm dosing just to make sure it was my shbg and it tested dead on 250.4mg/ml. I already had the primo tested and it tested out good.
 
I tanked my shgb so my labs were lower than I was expecting. I sent the test C to jano to confirm dosing just to make sure it was my shbg and it tested dead on 250.4mg/ml. I already had the primo tested and it tested out good.
When was the primo tested? When was it purchased.
 
I know this is an old post but I'm curious what info you are basing this on. Degradation testing I've seen shows no loss at all at 21 days, and minimal loss at 40 days (~3%).
Got a source by any chance? Not doubting you, but would be nice to have something definitive to lay this to rest.
 

Sponsors

Back
Top