Arail Pharmaceuticals - US Domestic

[Elektrobot]

Take this with a grain of salt but I've used primatine mist to set PRs, and albuterol for long cardio sessions

they always make me feel horrible after

Thank you

 

[erk253]

I’ve also used my hot water boiling pitcher. Heated up the water poured into a bowl then put my vials in the water. I just keep the water below the top of the vials. It’s worked great in the past.

 

[RockyP]

I’ve also used my hot water boiling pitcher. Heated up the water poured into a bowl then put my vials in the water. I just keep the water below the top of the vials. It’s worked great in the past.

This does work for crashed gear in general but this injectable anadrol is a different animal. Very very hard to keep in solution. Unlike TNE or other gear that happens to crash from being too cold in transit, etc.

 

[AllGoodThings]

Fill me in here you’re keeping something at an ambient temp of 105?! I was trying to follow and missed something somewhere. Are we talking about oils or suspension?

Rocky, myself, and quite a few others here use a baby wipe warmer for short term storage of compounds that tend to crash at normal room temps. At ~100° you do get some accelerated degradation of the API, as well as an increased oxidation rate with the oil, but the way we use this makes those factors of little to no concern. These crash-happy compounds are stored as normal, in a cool dark place, until they're ready to be used. At that point, I and many others use a mug warmer (as it reaches higher temps than the wipe warmer which are necessary here) to uncrash the gear, then proceed to store it in the wipe warmer until it's all used up. I don't like to leave anything in there longer than 3-4 weeks, personally, although longer is probably fine. I think overall this is less degrading on the compound than heating it to 150-180° every time you want to use it, and has the benefit of being more convenient as well.

 

[TallandSmall]

Yes he was, I just remembered that a few hours ago when I saw a label for a blend with albuterol

I don't like heart rate fucky fucky

Not sure if Helios or albuterol is for me

I use an albuterol inhaler before training, but I think thats dosed in mcg. Most blends I see with albuterol are 2mg/ml

Is this stuff worth the heart impact when trying to knock off the last few pinches?

I liked the Helios, but I was already on a clen cycle, so I was just switching from oral to injectable. I’ve got an albuterol mix for when I’m not running clen since it’s in and out, but I’m having second thoughts after what Steve said. I’ll have to research it more.

 

[DeodatoFulci]

I liked the Helios, but I was already on a clen cycle, so I was just switching from oral to injectable. I’ve got an albuterol mix for when I’m not running clen since it’s in and out, but I’m having second thoughts after what Steve said. I’ll have to research it more.

I’ll test drive the Helios next week and will report back. Its a beautiful amber color too. Haha.

 

[Arail]

Will drop this here as well.
Castor works really well with short h/l stuff.
View attachment 377822
2/20
View attachment 377821

https://www.mdpi.com/1996-1944/15/20/7245

We may just have to go ahead and give the castor a go just for the adrol inj. Thank you for posting this and always being so helpful!

 

[Billbo98]

Rocky, myself, and quite a few others here use a baby wipe warmer for short term storage of compounds that tend to crash at normal room temps. At ~100° you do get some accelerated degradation of the API, as well as an increased oxidation rate with the oil, but the way we use this makes those factors of little to no concern. These crash-happy compounds are stored as normal, in a cool dark place, until they're ready to be used. At that point, I and many others use a mug warmer (as it reaches higher temps than the wipe warmer which are necessary here) to uncrash the gear, then proceed to store it in the wipe warmer until it's all used up. I don't like to leave anything in there longer than 3-4 weeks, personally, although longer is probably fine. I think overall this is less degrading on the compound than heating it to 150-180° every time you want to use it, and has the benefit of being more convenient as well.

Thank you you brother for the explanation

 

[BALLISTIC]

We may just have to go ahead and give the castor a go just for the adrol inj. Thank you for posting this and always being so helpful!

This would be ideal. Let me know when you do, I'll be knocking at your email door.

 

[Billbo98]

This would be ideal. Let me know when you do, I'll be knocking at your email door.

100%

 

[bob357sig]

This does work for crashed gear in general but this injectable anadrol is a different animal. Very very hard to keep in solution. Unlike TNE or other gear that happens to crash from being too cold in transit, etc.

For me the Adrol starts out slightly crashed, but once it gets heated by about the third time, i get large hard crystals near the neck of the vial that I can’t get back into solution. Pip isn’t too bad for me but I just wonder how much less active compound im actually injecting with all those crystals stuck to the inside of the vial?

 

[Athleticfreak]

For me the Adrol starts out slightly crashed, but once it gets heated by about the third time, i get large hard crystals near the neck of the vial that I can’t get back into solution. Pip isn’t too bad for me but I just wonder how much less active compound im actually injecting with all those crystals stuck to the inside of the vial?

No way to ever actually tell exact but a lot less active compound. Flip the vial upside down on a candle warmer. It should dissolve the crystals.

 

[Whistles77]

No way to ever actually tell exact but a lot less active compound. Flip the vial upside down on a candle warmer. It should dissolve the crystals.

It does not. If it was that easy, the discussion around this would have been a lot shorter.

 

[Athleticfreak]

It does not. If it was that easy, the discussion around this would have been a lot shorter.

Never know with some of the ppl on here putting vials in microwave.

I uncrash Mast 200 and TNE and had vials with crystals up near neck and right below the top that would not uncrash, I flipped it over and done all clear liquid.

 

[Whistles77]

Never know with some of the ppl on here putting vials in microwave.

I uncrash Mast 200 and TNE and had vials with crystals up near neck and right below the top that would not uncrash, I flipped it over and done all clear liquid.

I'm one of the people who put it in the microwave......exactly because i've zero other way to uncrash it.

Can't compare Mast 200 and TNE to this Anadrol. These are very different beasts. I wouldn't dare do it unless i'd tried all the alternatives with TNE and Mast being easy as pi to uncrash.

 

[bob357sig]

Never know with some of the ppl on here putting vials in microwave.

I uncrash Mast 200 and TNE and had vials with crystals up near neck and right below the top that would not uncrash, I flipped it over and done all clear liquid.

I’m using a mug warmer. Funny thing is my last order, TNE came crashed but the Adrol didn’t. The TNE I heated up good and it came back no problem. The Adrol starts out not crashed but crashes after a few uses?

 

[RockyP]

I’m using a mug warmer. Funny thing is my last order, TNE came crashed but the Adrol didn’t. The TNE I heated up good and it came back no problem. The Adrol starts out not crashed but crashes after a few uses?

It’s just in the nature of injectable Anadrol brewed without super solvents (though see above Photon’s posts I think he has been able to get it to hold in castor with certain ratios of BA and BB). That’s been my experience as well as that of many others. When I used the Anadrol before it crashed it was perfectly fine. But once it crashes is when the problems start. I don’t know of many people who have been able to get it back into solution for any extended period of time.

The Anadrol has a very narrow window of solubility and is a bitch to brew without super solvents. It doesn’t behave like other crashed gear that can be warmed and then good to go.

 

[BALLISTIC]

The Adrol starts out not crashed but crashes after a few uses?

Yes, mine arrived fine, placed in drawer, came back a few days later fully crashed thick crystals. I've heated numerous times to use, and recommend heating at a mild temp like 175f for an extended period of time. If it's problematic after a few occasions I've wrapped in tinfoil to heat uniformly. I say this so that you heat, shake the shit out of it, then place back on heat, repeat as necessary until it's in full solution again. When I think it looks good I repeat at least 3x. Otherwise I found you will be drawing it up and with each subsequent use it's more difficult. Leaving me to believe it's not dosing correctly to some extent.

It’s just in the nature of injectable Anadrol brewed without super solvents. That’s been my experience as well as that of many others. When I used the Anadrol before it crashed it was perfectly fine. But once it crashes is when the problems start. I don’t know of many people who have been able to get it back into solution for any extended period of time.

The Anadrol has a very narrow window of solubility and is a bitch to brew without super solvents. It doesn’t behave like other crashed gear that can be warmed and then good to go.

This ↑↑↑

I fully agree and except the sacrifice of process to avoid the solvents, to me it's a trade that I'm aware of and prefer.

To answer your previous question, I keep indoor temp between 70f and 75f Rocky. Today I heated along side my TNE, dosed both in the same plunger at 1ml each. Got held up and before leaving the house about 1.5hrs later it was starting to crash again. Just for the timeframe you asked me about. TNE is still in solution.

 

[RockyP]

Yes, mine arrived fine, placed in drawer, came back a few days later fully crashed thick crystals. I've heated numerous times to use, and recommend heating at a mild temp like 175f for an extended period of time. If it's problematic after a few occasions I've wrapped in tinfoil to heat uniformly. I say this so that you heat, shake the shit out of it, then place back on heat, repeat as necessary until it's in full solution again. When I think it looks good I repeat at least 3x. Otherwise I found you will be drawing it up and with each subsequent use it's more difficult. Leaving me to believe it's not dosing correctly to some extent.


This ↑↑↑

I fully agree and except the sacrifice of process to avoid the solvents, to me it's a trade that I'm aware of and prefer.

To answer your previous question, I keep indoor temp between 70f and 75f Rocky. Today I heated along side my TNE, dosed both in the same plunger at 1ml each. Got held up and before leaving the house about 1.5hrs later it was starting to crash again. Just for the timeframe you asked me about. TNE is still in solution.

Thanks for the update brother. Appreciate it!

 

[Billbo98]

I’m using a mug warmer. Funny thing is my last order, TNE came crashed but the Adrol didn’t. The TNE I heated up good and it came back no problem. The Adrol starts out not crashed but crashes after a few uses?

Do you guys just set the vials themselves on the mug warmer? It doesn’t get the oils too hot? I’ve always used a heating blanket or my armpit lmao but hearing so many ppl talk about mug warmer my curiosity is peaked.