Beligas Injectable Anavar

[verylargeshoes]

I noticed this in the catalog my friendly Beligas sales rep sent me. Injectable Anavar at 50 mg/mL, claiming no EO. How likely is this to be a good idea?

Oxandrolone, 50mg (1 vial) – Beligas Pharmaceuticals

beligaspharma.to

It’s milky like their inj. Superdrol and YK-11. Looks a lot more like an aqueous suspension, but claims to be MCT oil.

 

[Photon]

Did you ever use their other milky stuff? lol
I remember you asking about the sdrol

 

[HeatherSwanson]

I pinned winstrol once. Never again. It was milky colored and was probably the worst pip I've ever had and my face broke out like a basement dweller without a hygiene ritual.

 

[verylargeshoes]

Did you ever use their other milky stuff? lol
I remember you asking about the sdrol

I tried the similarly white YK-11 a couple of times on a whim preworkout. Swayed by Vigorous Steve’s endorsement of injectable YK-11, though I know better. In the end it didn’t seem to have much of an immediate effect, and I wasn’t about to build an actual cycle around it. Didn’t give me any PIP or anything. Just, you know, untested SARM/steroid/maybe myostatin inhibitor APIs.

I don’t think my organs are going to get along with Superdrol, milky or not, oral or injectable. Too bad.

Anyway, I haven’t seen a lot of injectable anavar for sale, and a few threads debating whether it has any advantages given the good bioavailability of the oral and the need for harsher solvents to hold at reasonable concentrations. Maybe less GI / appetite impact for the sensitive?

I still don’t know why Beligas used skim milk as the carrier oil for these things, or why what they claims to be MCT looks like that if it’s an actual solution. Looks more like Test or Winstrol AQ to me. They don’t seem motivated to explain themselves when asked.

 

[verylargeshoes]

I pinned winstrol once. Never again. It was milky colored and was probably the worst pip I've ever had and my face broke out like a basement dweller without a hygiene ritual.

Every time I hear the “ground glass” stories about pinning winstrol I am impressed as fuck with the competitors who do that on a regular basis in contest prep. I’m not sure I’ve ever cared about winning any competition that much.

 

[Photon]

I still don’t know why Beligas used skim milk as the carrier oil for these things, or why what they claims to be MCT looks like that if it’s an actual solution. Looks more like Test or Winstrol AQ to me. They don’t seem motivated to explain themselves when asked.

Post in thread 'Qingdao Sigma Chemical Co., Ltd (International, US, EU, Canada and Australia domestic'

Nov 14, 2024

Can be about 60% BB to make it injectable. I think winstrol needs guiaacol for sure

Not really, we've done winstrol 50mg/ml without Guiacol in the past, but it crashes and looks milky, we discontinued it because of the continuous complaints about crashing badly.

Thanks for the info about 60% BB for anadrol, we might give it a try.

• Qingdao Sigma Chemicals

• 

I'm almost convinced its crashed gear.
Var and winny are similiar, very high melting points ~230c.
You need guaiacol for that, especially at doses at 50mg/ml.

That test base that you have at ~50mg/ml that keeps crashing has a melting point of 150c. Just imagine one at 230c.

If u dont plan to pin it, I would add either high amounts of g or heat the f out of it and see if it clears up. If it does, its crashed gear.

 

[Photon]

Thinking again, i don't think it's crashed.
Its just raw var powder floating around in the oil lol.

 

[verylargeshoes]

Thinking again, i don't think it's crashed.
Its just raw var powder floating around in the oil lol.

Yeah. Got any guesses as to the impact of that in practical use? I'm just academically curious at this point. I'm going to leave the orals alone for a good long while.

 

[Photon]

Yeah. Got any guesses as to the impact of that in practical use? I'm just academically curious at this point. I'm going to leave the orals alone for a good long while.

Does yours look like this?
Honestly, no clue about what to do with it.
I won't pin in..maybe some of the more seasoned vets can chime in?

@Spaceman Spiff @narta
Any idea how does this work?
Whys it milky?

J

Thread 'My homemade test-suspension :)'

Apr 16, 2021

Just brewed up 50mls of test-susp yum yum I forgot how much of a bitch susp can be to make if you ain't quick, but it turned out alright. 100mg/ml give or take. Hope you fellas like

• Jet Labs
• Replies: 19
• Forum: Steroid Homebrew

• 
• 

B

Thread 'Test Suspension (TNE - water based) Recipe'

Mar 26, 2014

Here is what I used for test suspension and it has been magical.

TNE Suspension
50mg/ml - 10ml
0.5g Test Base (0.4465ml)
0.2ml BA (2%)
1ml BB (10%)
0.3ml ps80 (3%)
8.0535ml distilled water

Steps:
1) Pre-heat warmer (my benchmark is set to 3/10 for a good 15 minutes)
2) Distill water and heat over warmer
3) If your test base is not micronized, use a mortar & pestle
4) Mix powder, BB, ps80. Mix as needed until clear and hot.
5) Dose water into vial(s) with 0.20 um filter and keep hot (set them on the warmer)
6) Filter BA into vial(s) and keep the vials on the...

• beedix
• Replies: 15
• Forum: Steroid Homebrew

 

[Nidus]

Does yours look like this?
Honestly, no clue about what to do with it.
I won't pin in..maybe some of the more seasoned vets can chime in?

@Spaceman Spiff @narta
Any idea how does this work?
Whys it milky?

J

Thread 'My homemade test-suspension :)'

Apr 16, 2021

Just brewed up 50mls of test-susp yum yum I forgot how much of a bitch susp can be to make if you ain't quick, but it turned out alright. 100mg/ml give or take. Hope you fellas like

• Jet Labs
• Replies: 19
• Forum: Steroid Homebrew

• 
• 

B

Thread 'Test Suspension (TNE - water based) Recipe'

Mar 26, 2014

Here is what I used for test suspension and it has been magical.

TNE Suspension
50mg/ml - 10ml
0.5g Test Base (0.4465ml)
0.2ml BA (2%)
1ml BB (10%)
0.3ml ps80 (3%)
8.0535ml distilled water

Steps:
1) Pre-heat warmer (my benchmark is set to 3/10 for a good 15 minutes)
2) Distill water and heat over warmer
3) If your test base is not micronized, use a mortar & pestle
4) Mix powder, BB, ps80. Mix as needed until clear and hot.
5) Dose water into vial(s) with 0.20 um filter and keep hot (set them on the warmer)
6) Filter BA into vial(s) and keep the vials on the...

• beedix
• Replies: 15
• Forum: Steroid Homebrew

Straight up looks like milk, anabolic milk

 

[pewex]

I bought test suspension from Opti and it looked just like that, milky. Tried pinning with a 22g but couldn't even push it through. I don't think a drop made it in me. I trashed it and got some TNE (oil) coming in from CN instead. Yes, it'll have solvents in it but at least it will inject

Never touching suspension or aqua solutions again.

 

[newguy2]

Every time I hear the “ground glass” stories about pinning winstrol I am impressed as fuck with the competitors who do that on a regular basis in contest prep. I’m not sure I’ve ever cared about winning any competition that much.

Isn't it commonly taken orally?

 

[RzSco]

Would this even make any difference to how hard it is on the liver if it’s just the same substance crushed up and made into a suspension?

 

[BP_6]

I'm going to ask the question. What is this thing with trying to convert every oral into an injectable? Not hating, just curious. I am aware you will get better overall bioavaiability. However, why not just take a bit more oral? You aren't saving your liver as the 17aa itself is what takes its toll on the liver and lipids.

Again, just seriously curious why go through the trouble?

 

[verylargeshoes]

I'm going to ask the question. What is this thing with trying to convert every oral into an injectable? Not hating, just curious. I am aware you will get better overall bioavaiability. However, why not just take a bit more oral? You aren't saving your liver as the 17aa itself is what takes its toll on the liver and lipids.

Some of these orals are hard on the digestive system when taken orally. I already have my fair share of issues there, so avoiding that is an interesting proposition. I agree that “bypassing first pass liver metabolism” feature doesn’t seem like a huge win, nor does faster effect.

I don’t plan to take this as my organs have called for a truce. I’m just curious about the particular form this one took, and also why we see lots of inj dbol, anadrol, superdrol, winstrol, even m-tren, but not anavar.

 

[BP_6]

Some of these orals are hard on the digestive system when taken orally. I already have my fair share of issues there, so avoiding that is an interesting proposition. I agree that “bypassing first pass liver metabolism” feature doesn’t seem like a huge win, nor does faster effect.

I don’t plan to take this as my organs have called for a truce. I’m just curious about the particular form this one took, and also why we see lots of inj dbol, anadrol, superdrol, winstrol, even m-tren, but not anavar.

OK, well if for whatever reason when you take it orally you have appetite/digestion/upset stomach issues that at least makes it make sense. Thanks for answering.

 

[verylargeshoes]

I bought test suspension from Opti and it looked just like that, milky. Tried pinning with a 22g but couldn't even push it through. I don't think a drop made it in me. I trashed it and got some TNE (oil) coming in from CN instead. Yes, it'll have solvents in it but at least it will inject

Arail has TNE without solvents, by the way. You may need to warm it up before injecting as it does revert to crashed state for me, but better that than guaiacol.

I threw out some gear with guaiacol in it that I’d used once two weeks ago, and that awful smell still hasn’t left the room.

 

[Jaxino]

I noticed this in the catalog my friendly Beligas sales rep sent me. Injectable Anavar at 50 mg/mL, claiming no EO. How likely is this to be a good idea?

Oxandrolone, 50mg (1 vial) – Beligas Pharmaceuticals

beligaspharma.to

It’s milky like their inj. Superdrol and YK-11. Looks a lot more like an aqueous suspension, but claims to be MCT oil.

The real question is: why resort to using such an underwhelming anabolic like Anavar — and even inject it? I’d much rather administer Anadrol by injection, if only it didn’t wreak havoc on my CRP levels...

 

[verylargeshoes]

The real question is: why resort to using such an underwhelming anabolic like Anavar — and even inject it? I’d much rather administer Anadrol by injection, if only it didn’t wreak havoc on my CRP levels...

Some of us have more delicate constitutions...

 

[Photon]

I'm going to ask the question. What is this thing with trying to convert every oral into an injectable? Not hating, just curious. I am aware you will get better overall bioavaiability. However, why not just take a bit more oral? You aren't saving your liver as the 17aa itself is what takes its toll on the liver and lipids.

Again, just seriously curious why go through the trouble?

I have TNE which i pin pwo, but i don't always pin a full 1ml..In that case why not just fill it up with something. There might be a slight gain (or not) by bypassing the first pass, either way since I was going to pin anyways, might as well just fill it up to 1ml vs poping an oral separately.