MESO-Rx
Anabolic Steroids
I should have but did not measure the temp. It was not too hot for me to hold though. I imagine at most it hit 150f. And I’m storing it in the dark at 70f (it’s in a kitchen cabinet). What surprised me even more is that it crashed while still stirring. My last batch of bold cyp held fine (and is still holding fine) at 2/25
Could be the raws hard to say. I would shoot for hotter since you dont have to worry about hitting the melting point too quickly. Once you hit the melting point the risk of degradation is much higher depending on the compound. The bb will hold more when heated
I’ll try heating it again. I heated it at 20, then again when I made it 22.5 bb, I didn’t hear it again after adding enough to get to 25
This is my second time brewing and my second time with it being a pain in the ass lol. Last time it wasn’t nearly this painful though. How do you brew it? I’m all for working smarter not harder
Haven't brewer bold cyp yet.. just bold u/eq.. that's easy peasy lol.. you would think cypionate would be much harder..
I’ve brewed about 10 different compounds now, and the only ones that gave me issue are bold cyp and DHB (unfortunately I had to trash the DHB). Bold cyp isn’t as easy as adding a little heat for 30 mins, letting cool for an hour, then filtering. Maybe next time I’ll get it the first time. 3rd times a charm.
I heard a lot of comments about major PIP with bold cyp, but I brewed mine in MCT at 2/25 and still had no issues with any PIP at all.
210mg (which I ended up at exactly because those 98%+ Bolde Cyp raws may be close to 100% purity in retrospect) is certainly prone to crashing at 2/20, so if you've not labtested the finished product, the issue may be due to it being higher than 210mg due to underestimating raw purity.
I got the raws from panda, not sure who you got yours from. But I’m sure you probably figured out I wanted 200 mg/ml with a 5% OD. I planned to brew 120mL (119 to more more precise) but it’s closer to 125 mL after adding 6 more mL of bb to bring it up to 25%. Assuming ~100% purity it should be right at 200 mg/mL (more likely to be 196-198 I suppose).
Lower doses? Why not 100 mg/ml
I don't like injecting anymore oil than I have to. I've never used high concentration gear, but I'll usually bump up the dosage a little more than what you would normally see, when I can get away with it. I certainly don't want to go lower concentration
I made EQ once with basically 70% bb. Lol
Because if you run the bb to 30-40. To get it to hold, then make a vial of sterile oil, or mix in a syringe with test with 10-15 bb, it would even out.
