MESO-Rx Sponsor Genuine Steroid Powder Manufacturer-AASraw

$8/g vs $7.60/g on the larger qty?
Their test C is $1.8/g vs $0.9/g at 100g vs 1kg. However trestolone goes from $35/g to $19.5g at 10g vs 1kg. The discount discrepancy seems lower for more expensive and exotic compounds. If I would guess, their costs for these are higher so the discount is not strictly percentual across all compounds.
 
Vacuum seal it and store it away from direct sunlight/heat.
Well from the photos i was sent by the vendor it might already be sealed in a pouch, and im wondering if it is a good pouch or if i should get a dessicant and an oxygen absorber to toss in with it when i vacuum seal it or if it is well packed in a sealed packet that i shouldnt even open until needed
 
Well from the photos i was sent by the vendor it might already be sealed in a pouch, and im wondering if it is a good pouch or if i should get a dessicant and an oxygen absorber to toss in with it when i vacuum seal it or if it is well packed in a sealed packet that i shouldnt even open until needed

It comes sealed but not vacuum seal quality. I would throw some oxygen absorbers in then vac seal it instead.

On a side note, looks like the new NPP batch that's white is much better quality. ~95% (based off others Janos testing) -- I don't use npp
 
It comes sealed but not vacuum seal quality. I would throw some oxygen absorbers in then vac seal it instead.

On a side note, looks like the new NPP batch that's white is much better quality. ~95% (based off others Janos testing) -- I don't use npp
let me ask this before i order, is the humidity anywhere near an issue compared to the o2? at least the brief exposure it will have before i vacuum seal it? or would a desiccant be better? as i understand an o2 absorber needs a little moisture in it to do its job so what do you think?
 
let me ask this before i order, is the humidity anywhere near an issue compared to the o2? at least the brief exposure it will have before i vacuum seal it? or would a desiccant be better? as i understand an o2 absorber needs a little moisture in it to do its job so what do you think?

i suppose the act of vacuum sealing would thusly remove any humid air so maybe it was a dumb question
 
let me ask this before i order, is the humidity anywhere near an issue compared to the o2? at least the brief exposure it will have before i vacuum seal it? or would a desiccant be better? as i understand an o2 absorber needs a little moisture in it to do its job so what do you think?

Both are cheap.
You can just get both and throw it in lol
 
Back
Top