MESO-Rx
Anabolic Steroids
How I make test base 100
- Thread starter XmadXscientist
- Start date
XmadXscientist
Member
@TideGear
Nice you’re doing it right and not ghetto style. Do you use a thermometer to watch temp? I did for awhile before I figured out where my temps are and would increase heat real slow since I made something smoke once when I turned it up high from the get-go.
Nice you’re doing it right and not ghetto style. Do you use a thermometer to watch temp? I did for awhile before I figured out where my temps are and would increase heat real slow since I made something smoke once when I turned it up high from the get-go.
TideGear
Member
I use that infrared thermometer in the pic.
So to get the raws to melt you put them in the beaker and increase temp slowly? How long does it take for them to melt?
It says the melting point of winstrol is 242 C. That's hot af and I know it didn't get that hot before it started smoking
XmadXscientist
Member
Not sure how long it takes but those infrared thermometers probably aren’t going to be terribly accurate unless you’ve spent significant $$$
@XmadXscientist i tweaked this a little. But a 50ml test batch held down to 70 degrees no crystals. So i made a bigger batch. Cooling it now.
XmadXscientist
Member
How so and how long has it been since you made it? Bases can crash weeks later.
24 hour mark is tonight. But i let it get to about 63 degrees and no crystals.
I used mct vs. Mig. And went with 2/20/20/15. Just put all in beaker at same time. Cover with foil, heat, cool, done.
I used mct vs. Mig. And went with 2/20/20/15. Just put all in beaker at same time. Cover with foil, heat, cool, done.
XmadXscientist
Member
If it’s 15% guaiacol you used thenbit should be good, I would hold it for a week or so to make sure before sharing
I am not a fan of high guaiacol so tried to come up with the minimum amount possible. Might be attempting injectable var again this weekend if supplies are waiting for me.
I appreciate the info. There's a lot of higher end compounds i never brewed before. I'm always down to learn and share the info.If it’s 15% guaiacol you used thenbit should be good, I would hold it for a week or so to make sure before sharing
I am not a fan of high guaiacol so tried to come up with the minimum amount possible. Might be attempting injectable var again this weekend if supplies are waiting for me.
I'm a fan of low solvent/low heat. But also a fan of dump in and then heat and cool. Babying a brew is tough when you're doing it for work.
Let me know how the var works out. I plan to get some trne base next reup and want to compare notes with @Iron Vett since he is interested in that one as well.
XmadXscientist
Member
I’ll probably post it up like this one if I can get it to work. I’ve done it at 15mg/ML with 25-30mg/ML test base and 25mg/ML Tren Base I believe, but it crashed after a couple months with a low guiacol recipe which I think is in the brewporn thread somewhere.
