I know a guy with Tren Ace raws. He successfully brewed Test Enanthate 250mg, Deca 200mg, and Masteron Enanthate 200mg from same source without issue using the exact same components and techniques. 2% BA 18% BB Safflower oil (small difference below on oil source). Crystal clear, just took time to dissolve using auto stirrer.
1) Dissolved first in BA/BB at low heat (120F or less) dissolved clear then oil added quickly formed a thick gunk at the bottom of the beaker and was cloudy. Filtering took care of the cloudiness and supposedly his initial batch worked fine for effect but obviously with all that residue was underdosed and ruined the glassware. Safflower oil was USP.
2) Absolutely no heat BA/BB and oil together at room temp. Gunk immediately formed at bottom of beaker not allowing auto-stirrer to spin and stuck it to the side. Periodic stirring leaves cloudy solution and thick gunk at bottom that can be scrapped up onto stirring rod. Safflower oil was about 80% from grocery store which he used to brew all other product and maybe 15% from USP batch but results identical or worse than #1.
Looks similar to pictures taken a while ago for another user when the conclusion was "he burned it with heat" but in this case #1 was not exposed to heat higher than 120F and the second attempt NEVER had heat and room + product temp was 70F degrees.
As no other raw behaved remotely like this and was smooth sailing for him. I'm thinking there is a major issue with his TA product. Could it be the USP safflower oil (medlabsupply)? I can't imagine that and results where it was even a small component vs the grocery store were identical. Thoughts on this?
1) Dissolved first in BA/BB at low heat (120F or less) dissolved clear then oil added quickly formed a thick gunk at the bottom of the beaker and was cloudy. Filtering took care of the cloudiness and supposedly his initial batch worked fine for effect but obviously with all that residue was underdosed and ruined the glassware. Safflower oil was USP.
2) Absolutely no heat BA/BB and oil together at room temp. Gunk immediately formed at bottom of beaker not allowing auto-stirrer to spin and stuck it to the side. Periodic stirring leaves cloudy solution and thick gunk at bottom that can be scrapped up onto stirring rod. Safflower oil was about 80% from grocery store which he used to brew all other product and maybe 15% from USP batch but results identical or worse than #1.
Looks similar to pictures taken a while ago for another user when the conclusion was "he burned it with heat" but in this case #1 was not exposed to heat higher than 120F and the second attempt NEVER had heat and room + product temp was 70F degrees.
As no other raw behaved remotely like this and was smooth sailing for him. I'm thinking there is a major issue with his TA product. Could it be the USP safflower oil (medlabsupply)? I can't imagine that and results where it was even a small component vs the grocery store were identical. Thoughts on this?
