MedLabGear - Accessory and Supply Shop

It makes more sense to.me to order the draw needle on the syringe combo and pin needles separate so there's less chance of any contamination. Pin needle is only opened when ready to pin. Just my 2 cents, I'm not a professional
 
3cc and 25g can be hard to push the plunger down with some carrier oils. Just FYI. I had pharmacom test e300 and it was a pain in the ass to push that plunger.

1cc syringe and 25g needle is VERY easy to push the same oil through.

Just a thought.

@MedLabGear, will you have 1cc exel syringes with the "baby carrot"?? Or are they not made?
 
3cc and 25g can be hard to push the plunger down with some carrier oils. Just FYI. I had pharmacom test e300 and it was a pain in the ass to push that plunger.

1cc syringe and 25g needle is VERY easy to push the same oil through.

Just a thought.

@MedLabGear, will you have 1cc exel syringes with the "baby carrot"?? Or are they not made?
I use 27g for everything i pin
 
For drawing out of the vial, I would switch those 18g with 20 or 21... the 18s beat up my stopper quite a bit. Especially if you are doing trt where you'll be pulling out of the vial many many times. Just something that I found. If blasting then 18g is fine. 20 pulls the same just not as thick as the 18.
Had the same problem kept getting stopper in my bottles 20 works good
 
3cc and 25g can be hard to push the plunger down with some carrier oils. Just FYI. I had pharmacom test e300 and it was a pain in the ass to push that plunger.

1cc syringe and 25g needle is VERY easy to push the same oil through.

Just a thought.

@MedLabGear, will you have 1cc exel syringes with the "baby carrot"?? Or are they not made?

I have this same question now. I thought the Excel 1cc syringe had the baby carrot as well. Is that not correct?
 

Sponsors

Latest posts

Back
Top