Oral suspension recipes

[AlwaysHungry]

Same. No difference with taking in a capsule, pill or suspension

So it's working like it should like Injection and you see gains.
That may be very interesting I've bored to he'll to inject all the time.

How many times a day you dose it 2-3?
Also tren suspension must be good too I guess

 

[Nilatac]

So it's working like it should like Injection and you see gains.
That may be very interesting I've bored to he'll to inject all the time.

How many times a day you dose it 2-3?
Also tren suspension must be good too I guess

I didn't took orals steroids in injectable form to make a comparison but in oral form it's working the same if you take in suspension, capsule or in a pill form. If you ingest the substance it's start doing what it's suppose to do. It's like subq or IM injection. It's in you it's doing his job.

I take my oral steroids all at once. Usually I take sdrol or drol and it has a enough half life do working most of the day. I am a high dose guy and even after one half life the dose is higher than what normal people take.
When I take dbol I take in 2 doses am and pre working another dose.

Tren suspension you must brew to be injectable. Mtren is the oral form.

 

[Stayhealthy]

I used vegetable glycerin and vodka (I had no 190 proof available) to make a 20mg/ml suspension of Cialis (tadalafil).

It was 177 ml (6 oz) of Walmart brand vegetable glycerin USP. I added the 5 grams of tadalafil to the glycerin, topped off the beaker to the 250 ml line with costco vodka, put the beaker on my stirring hot plate and let it stir for about 15-20 minutes with heat on low. I added Mio for coloring and flavor. It all went in a small glass bottle from a Japanese sparkling apple drink I got at an Asian market.

I’ll update this post in about a week when I know how the suspension holds up.

p.s. Cialis raw powder doesn’t mix very well in the glycerin, the vodka helped but the stirring hot plate is what made it all possible. Shaking would’ve taken three days probably (for cialis). This suspension has to be kept somewhere safe so no one thinks it’s juice…I did label the bottle “20 mg/ml Cialis”

My suspension didn’t hold up as I would’ve liked but it’s still doable. It settles some but with some vigorous shaking for 10 seconds everything is evenly distributed. I draw out my dose and put it away until next time.

 

[Nilatac]

My suspension didn’t hold up as I would’ve liked but it’s still doable. It settles some but with some vigorous shaking for 10 seconds everything is evenly distributed. I draw out my dose and put it away until next time.

That's what it supposed to do. It's a suspension not a solution

 

[Stayhealthy]

That's what it supposed to do. It's a suspension not a solution

That makes sense, thanks.

I was optimistic after reading some study about a suspension being stable and homogenous after initial mixing with Ora plus, but that was probably using a different powder also

 

[WeaponPharma]

POWDER TO LIQUID ORAL CONVERSIONS
(Instructions below)

ANADROL
Powder: per 1 gram of Oxymetholone
Produces: Highest concentration made – 50mg/ml

Requirements:
1 gram of Oxymetholone powder
1 Beaker suitable for holding the volume of liquids
8.4ml of PEG 300
10.5ml 190 Proof Grain Alcohol

ANAVAR
Powder: per 1 gram of Oxandrolone
Produces: Highest concentration made – 20mg/ml

Requirements:
1 gram of Oxandrolone powder
1 beaker suitable for holding the volume of liquids
9.8ml of PEG 300
39.2ml of 190 Proof Grain Alcohol

https://thinksteroids.com/steroid-profiles/arimidex/ (ARIMIDEX)
Powder: per 1 gram of Anastrozole
Produces: Highest concentration made – 5mg/ml

Requirements
1 gram of Anastrozole powder
1 beaker suitable for holding the volume of liquids
19.9ml of PEG 300
179.1ml of 190 Proof Grain Alcohol

CLOMID (Version I)
Powder: per 1 gram of Clomiphene Citrate
Produces: Highest concentration made – 50mg/ml

Requirements:
1 gram of Clomiphene Citrate
1 beaker suitable for holding the volume of liquids
7.6ml of Glycerol
11.3ml of 190 Proof Grain Alcohol

CLOMID (Version II)
Powder: per 1 gram of Clomiphene Citrate
Produces: Highest concentration made – 50mg/ml

Requirements:

1 gram of Clomiphene Citrate
1 beaker suitable for holding the volume of liquids
8.4ml of PEG 600
10.5ml of 190 Proof Grain Alcohol

DIANABOL
Powder: per 1 gram Methandrostenolone
Produces: Highest concentration made – 50mg/ml

Requirements:

1 gram of Methandrostenolone powder
1 beaker suitable for holding he volume of liquids
19ml of 190 Proof Grain Alcohol

FEMARA
Powder: per 1 gram of Letrozole
Produces: Highest concentration made – 5mg/ml

Requirements:

1 gram of Letrozole powder
1 beaker suitable for holding the volume of liquids
19.9ml of PEG 300
179.1ml of 190 Grain Proof Alcohol

NOLVADEX (Version I)
Powder: per 1 gram of Tamoxifen Citrate
Produces: Highest concentration made – 20mg/ml

Requirements:

1 gram of Tamoxifen Citrate
1 beaker suitable for holding the volume of liquids
19.6ml of Glycerol
29.4ml of 190 Proof Grain Alochol

NOLVADEX (Version II)
Powder: per 1 gram of Tamoxifen Citrate
Produces: Highest concentration made – 20mg/ml

Requirements:

1 gram of Tamoxifen Citrate
1 beaker suitable for holding the volume of liquids
9.8ml of PEG 600
39.2ml of 190 Proof Grain Alcohol

PROVIRON
Powder: per 1 gram of Mesterolone
Produces: Highest concentration made – 50mg/ml

Requirements

1 gram of Mesterolone
1 beaker suitable for holding the volume of liquids
8.4ml of PEG 300
10.5ml of 190 Proof Grain Alcohol

WINSTROL
Powder: per 1 gram of Stanozlol
Produces: Highest concentration made – 25mg/ml

Requirements:

1 gram of Stanozlol
1 beaker for holding the volume of liquids
7.8ml of PEG 300
31.2ml of 190 Proof Grain Alochol

For all of the above conversions requiring PEG and 190 Proof Alcohol, use the following procedure;
Place a sufficient amount of water in a pan and place on the stove
Remove from heat when the water reaches boiling temperature
Place the powder and the PEG in the beaker
Immerse the beaker in the pan of water so that the water is level with the top of the contents of the beaker
Gently swirl or stir the contents of the beaker until the solution is clear (reheat the water if necessary)
Remove the beaker from the water
Allow the PEG to cool down
Slowly add the 190 Proof Alcohol to the mixture
Gently stir until fully mixed.

For all of the above conversions where PEG is not required, use the following procedure;
Mix powder and 190 Proof Alcohol in the beaker
Gently swirl or stir the contents of the beaker until the solution is clear
The majority of powders which do not require PEG will dissolve readily but those that are troublesome, refer to the heating procedure as outlined above.
In the event that 190 Grain Alcohol (EverClear) is unavailable, then substitute Bacardi 151.
List of Materials:
190 Proof Grain Alcohol or Bacardi 151, PEG 300, PEG 600. Powder, beaker, stir rod, suitable container for holding finished preparation. Weighing scales accurate to 0.001g (if preparing yourself)

You never want to be in a situation where you have to shake it up to use it. While it’s good to shake a solution to ensure even distribution throughout the liquid, you should always prefer to have all of your powder dissolved and not to be able to see any crystals floating around in the liquid
Ideally you want a solution, not a suspension. If you have a preparation which is little more than powder sitting in liquid, or where after swirling it visibly falls down to the bottom of the vial, it is utterly useless for getting any kind of consistency of dosing. Anything worthy of being called a suspension should be fairly stable after shaking such that you can take your time to draw it.


this isnt mine. i wish i save the persons man to give them credit but i save this.

This is awesome

Since each recipe lists the mg/ml that will be brewed, and each recipe calls for 1gm of the active ingredient, does one divide the relevant mg per ml (eg 50 or 25 mg/ml) by 1000 to arrive at the total mls each recipe will create?

Sorry if this is a stupid newbie qn

 

[pistonpump]

How much Cialis do u add to 30ml to make 20mg/ml? 6 grams? That doesn't sound right, 6 grams can dissolve into one oz (30ml)? I'm using humco

 

[UncleBuns]

How much Cialis do u add to 30ml to make 20mg/ml? 6 grams? That doesn't sound right, 6 grams can dissolve into one oz (30ml)? I'm using humco

Bro. 20mg/ml = x/30ml. It's literally junior high level math. C'mon man.

Hint: 6 grams is 6000 mg and would give you 200g/ml

Humco isn't going to dissolve anything. It's for making a suspension. The added compound is literally suspended in the carrier, not dissolved.

 

[pistonpump]

Bro. 20mg/ml = x/30ml. It's literally junior high level math. C'mon man.

Hint: 6 grams is 6000 mg and would give you 200g/ml

Humco isn't going to dissolve anything. It's for making a suspension. The added compound is literally suspended in the carrier, not dissolved.

Yea yea dissolve suspended whatever. thanks

 

[narta]

Yea yea dissolve suspended whatever. thanks

If you can't comprehend the difference between dissolve and suspend you better stay off making your own concoctions.

 

[Mrgiuoco]

Just double checking guys, might be a little dumb question because I have never made it for but with clomid, nolva and aromasin I can just mix it with the humco and shake? Assuming I have the right mg/ml concentration ?

 

[Deimosx]

Where does one get 190 proof alcohol ? Bacardi 151 has been out of production for a couple of years now. Everclear may have gone the way of the Do Do bird as well.

hey bro, culinarysolvent.com has some food grade alcohol you can use for that kind of stuff. I've bought some from them before and its good.

 

[klokke23]

Just double checking guys, might be a little dumb question because I have never made it for but with clomid, nolva and aromasin I can just mix it with the humco and shake? Assuming I have the right mg/ml concentration ?

Use the search button to check if others have done with success. Because some raws clump up in humco. But just a few. I think ralox was one to clump.
It's good to make sure before u mix

 

[Mrgiuoco]

Use the search button to check if others have done with success. Because some raws clump up in humco. But just a few. I think ralox was one to clump.
It's good to make sure before u mix

Cheers bro