PIP Free Glutathione

[HereToTeachAndLearn]

I finally figured out a PIP free glutathione recipe. The key was using 2% lidocaine injection liquid to replace BAC water in half of the final volume.

My example:

30ml total
200mg/ml

15ml 2% lidocaine injection liquid
6.3g reduced glutathione raw (5% overage)
2% BA (0.6ml)

Heated to 60C and stirred for about 30 minutes. Was very white and cloudy.

Slowly added NaOH pellets until it turned clear. Very little needed.

Once clear I added enough BAC water to make 30ml total. I believe it was something like 8-9ml.

Filtered into a 30ml vial and injected into quad.

ZERO discomfort and ZERO PIP after 3 consecutive days of injections.

If you want information on how to source low cost Pharma Lidocaine and BAC water, PM me and I will let you know how I purchased.

 

[Lil_swole87]

Interesting could you hit me up

 

[micro2000]

I finally figured out a PIP free glutathione recipe. The key was using 2% lidocaine injection liquid to replace BAC water in half of the final volume.

My example:

30ml total
200mg/ml

15ml 2% lidocaine injection liquid
6.3g reduced glutathione raw (5% overage)
2% BA (0.6ml)

Heated to 60C and stirred for about 30 minutes. Was very white and cloudy.

Slowly added NaOH pellets until it turned clear. Very little needed.

Once clear I added enough BAC water to make 30ml total. I believe it was something like 8-9ml.

Filtered into a 30ml vial and injected into quad.

ZERO discomfort and ZERO PIP after 3 consecutive days of injections.

If you want information on how to source low cost Pharma Lidocaine and BAC water, PM me and I will let you know how I purchased.

Did you test the pH to make sure you're not too alkaline after adding the NaOH?

 

[HereToTeachAndLearn]

Did you test the pH to make sure you're not too alkaline after adding the NaOH?

pH was about a 5 prior to adding NaOH. Ended up at about a 6.

 

[iris]

I finally figured out a PIP free glutathione recipe. The key was using 2% lidocaine injection liquid to replace BAC water in half of the final volume.

My example:

30ml total
200mg/ml

15ml 2% lidocaine injection liquid
6.3g reduced glutathione raw (5% overage)
2% BA (0.6ml)

Heated to 60C and stirred for about 30 minutes. Was very white and cloudy.

Slowly added NaOH pellets until it turned clear. Very little needed.

Once clear I added enough BAC water to make 30ml total. I believe it was something like 8-9ml.

Filtered into a 30ml vial and injected into quad.

ZERO discomfort and ZERO PIP after 3 consecutive days of injections.

If you want information on how to source low cost Pharma Lidocaine and BAC water, PM me and I will let you know how I purchased.

In my neck of the woods, a iv or injection of glutathione is more than 100gbp. Mg/ml vary a lot, though. This is cool