MESO-Rx
Anabolic Steroids
Its good enough actually its acceptable however if its got that solvent as stated above my reply then that's hella dangerous. However 92% should be safe.. Not sure what to make of the report. I'll wait for jano to say something. Actually he already left a reply. Nvm hahah
I appreciate the correction. Can purity be calculated or at least approximated using those test results?
So in other words 92% BU with about an additional 5% unbound ester. Honestly, it probably better than the majority of BU that's been coming in.
Yeah, in looking into it a bit I guess GCMS is more qualitative analysis whereas HPLC is quantitative analysis.
I'll admit this is more mental masturbation for me at this point, so if I make mistakes, I hope someone will correct me kindly.
I ordered quite a bit of the raw boldenone, And I'm glad I did obviously it's a good product, The raw tren e I got was great as well, their prices are high but they seem to be somewhat decent, And I've been happy with their customer service, I had some issues with them and they worked them out with me and fixed all the problems I had, They even resent a package of mine that was destroyed or ripped apart during shipping, I really can't complain about them at all they've been good with me
Same here
You can't interpret GCMS like that.
Depends on how you run it. You can absolutely run GCMS quantiatively, but area % should never be assumed to be purity unless in specific defined scenarios in ANY mode of analysis, HPLC, GCMS or anything.
GCMS might see compounds HPLC can't and vice versa, but again area % should never be assumed to be purity unless in specific defined scenarios in ANY mode of analysis, HPLC, GCMS or anything.
All due respect, I don't think you're going to have a good time recrystallizing a compund that's not a crystal at room temperature without proper experience and equipment.I personally would not like this and be angry and attempt recrystallization it and obtain a higher purity
If you want me to do this for you contact me. I can do a pass over it and get you to 96% pure or higher. I'll do it for free
I started this project with the goal of purifying trenbolone acetate into large, high-purity crystals that can serve as a visual and chemical indicator of quality—ideally 98% purity or higher. The following is a chronological summary of the steps I’ve taken so far:
1. Initial Material
I began with trenbolone acetate in powder form. It appeared to have minimal binders or fillers, as it readily dissolved in acetone with no obvious residue.
2. Solvent Preparation
I used store-bought acetone as my solvent. Because water content interferes with crystallization, I...
That's an interesting thing I never thought of.. It is a damn oil... I wonder how that would be done .. would you bring it back as an oil or would you have to do it at a lower temperature.. have to chil it in a freezer or something...
No, I perfectly believe you You're right. Oil is gonna be a hard time
My suspicion is it would have to be cold.
I read that undecylenic acid is liquid at room temperature because of its structure.. like unsaturated fats.. saturation is referred to the number of bonds the carbon could make with hydrogens... 3 bonds with hydrogen and one to another carbon, or 2 with hydrogen and 2 with left and right carbons on a chain... so unsaturated is when the carbon makes a double bond, and the double bond are diagonal.. so the zig zag chain couldn't pack but one chain slides over the others and so on, at room temperature pretty much
Yeah, I read a paper on this subject. I will attempt some experiments on some liquid raws on my own. My lab equipment is growing in extensiveness, so I can't wait to keep chucking money at this.
Just get a hand pump.
