So i tried to make a 500mg/ml batch of test cyp. Measured,heated and upon vacuum filtration it solidified what am i doing wrong?

[trensican214]

Got some test cyp raw today and wanted to make a 500mg/ml batch for myself came outta aas raws. Everything went fine but once started filtration it solidified. So what am I doing wrong.. im using the vacuum pump filter system. Used the steroid calculator for measurement and still messed up its been cooking for over 30min on the hot plate at 100c..off and on but won't filter

 

[trensican214]

500 mg/ml Test c, good freaking luck

Yeah didn't work lol.. it's all good a learning curb.. was a thought and went for it.. you never know until you go.

 

[eery]

Yeah didn't work lol.. it's all good a learning curb.. was a thought and went for it.. you never know until you go.

if you did a search on here or on the forum or even asked chatgpt, you'd probably have learned it without all the back and forth though.

 

[justtrtbro]

Lol glorious read

 

[trensican214]

Test cyp can be made between 200 and 300 mg and for 100 ml of finish product you need 20 and 30 gram of test cyp raws. Raws aren't 100% purity so you put extra 5% more as they usually are 96-98%. Some raws come in purity lower than 96%.
Tren e 200-250mg is usually made and you need between 20 and 25 g of raw for 100 ml finish product. Add 5% more for the purity to compensate and it's 21g or 21,25g.
Tren ace 100mg and same formula applies here

Each ester can be made,hold and be usable at a certain mg/ml. See what a ugl sell and that's the limit usually. If that was the question.

Man thst shit yelled up over night so I chucked it.. I made another using that same calculator to the T and it's doing the same thing this was for 200ml at 250mg per ml. It won't pass thru the filter and once cools off it gels up like cold cooking oil. Heated at 100c for 20min then ran thru filter

 

[Photon]

Man thst shit yelled up over night so I chucked it.. I made another using that same calculator to the T and it's doing the same thing this was for 200ml at 250mg per ml. It won't pass thru the filter and once cools off it gels up like cold cooking oil. Heated at 100c for 20min then ran thru filter

It sounds like your ml or mg measurements are kind of off. How are you accurately measuring the mg of powder and ml of liquid? The markings on the beakers are not accurate.

GSO 2% BA 25% BB 250MG/ML should hold without crashing.