Trainghard1212
New Member
I have been researching for answers on both of these vaccume setups
Not seeing much said about stericap vaccume setups
Confused on which way to go I have ordered
DC12V Mini Vacuum Pump Negative Pressure Suction Pump 5L/min 120kpa
I figure best way to get answers is to start a thread on
I'm not the sharpest tool in the shed
I have been trying to figure out which way to go about it
I'll appreciate any advice and ya time
There 2 setups
Stericup Quick Release-GP sterile vacuum filtration system combines a 500 mL Steritop bottle top filter unit, which uses a 0.22 µm pore size fast flow PES Express PLUS membrane, with a 500 mL receiver flask for sterilizing tissue culture media, protein & DNA.
Sterile, 5 L–10 L process volume, 0.22 µm pore size, polyethersulfone membrane, sterilized by gamma irradiation
Which way should I go about it there both priced almost the same the cap little more , will pump run the stericap
Different filters different plastics?
polypropylene = good & Polyethersulfone=bad
Anyway I'll appreciate any help
Thanks heaps
>-----ARCHER----->
Not seeing much said about stericap vaccume setups
Confused on which way to go I have ordered
DC12V Mini Vacuum Pump Negative Pressure Suction Pump 5L/min 120kpa
I figure best way to get answers is to start a thread on
I'm not the sharpest tool in the shed
I have been trying to figure out which way to go about it
I'll appreciate any advice and ya time
There 2 setups
Stericup Quick Release-GP Sterile Vacuum Filtration System
- Product Code: S2GPU05RE
- Download
- Zoom
![S2GPU05RE[203849-ALL].jpg](/community/proxy.php?image=https%3A%2F%2Fwww.merckmillipore.com%2Fwaroot%2Fmedium%2FS2GPU05RE%5B203849-ALL%5D.jpg&hash=86b35e27a6135f6ac401630907c281d5)
Stericup Quick Release-GP sterile vacuum filtration system combines a 500 mL Steritop bottle top filter unit, which uses a 0.22 µm pore size fast flow PES Express PLUS membrane, with a 500 mL receiver flask for sterilizing tissue culture media, protein & DNA.
SteriCap PLUS
- Product Code: SCGPCAPRE
Sterile, 5 L–10 L process volume, 0.22 µm pore size, polyethersulfone membrane, sterilized by gamma irradiation
Which way should I go about it there both priced almost the same the cap little more , will pump run the stericapDifferent filters different plastics?
polypropylene = good & Polyethersulfone=bad
Anyway I'll appreciate any help
Thanks heaps
>-----ARCHER----->
Last edited: