Test has crashed?

[db2]

How can I tell if my test has fallen out of solution? I am looking at my vial of gtp sustanon250 and I notice about 8 specs towards the top of the vial that look like crystals. They are stuck to the sides. The reason I ask is, when everyone states there test has fallen out, they state they can see all the powder at the bottom of the vial. There is no powder at the bottom of mine. Did my test crash, or is it just fine? Thanx in advance for all replies.

 

[THL]

How can I tell if my test has fallen out of solution? I am looking at my vial of gtp sustanon250 and I notice about 8 specs towards the top of the vial that look like crystals. They are stuck to the sides. The reason I ask is, when everyone states there test has fallen out, they state they can see all the powder at the bottom of the vial. There is no powder at the bottom of mine. Did my test crash, or is it just fine? Thanx in advance for all replies.

Try heating the vial with a blow dryer or hot water. The test will disolve better when the oil is warm. If the few crystals do not go away when heated, it is posible that you have some stray matter floating it there. Have you used this test yet? Sometimes little peices of the stopper can end up floating around after you poke a needle in the bottle a couple of times.

 

[db2]

Try heating the vial with a blow dryer or hot water. The test will disolve better when the oil is warm. If the few crystals do not go away when heated, it is posible that you have some stray matter floating it there. Have you used this test yet? Sometimes little peices of the stopper can end up floating around after you poke a needle in the bottle a couple of times.

hey bro, yes i have used this test vial for about 4 weeks now. i am pretty sure it is crystals, as the apperance of the specs look like tiny diamonds, not rubber. i will try and heat the vial with the blow dryer first, about how long should i heat it? Also, I sould heat and shake it, to get it back in,right?

 

[THL]

hey bro, yes i have used this test vial for about 4 weeks now. i am pretty sure it is crystals, as the apperance of the specs look like tiny diamonds, not rubber. i will try and heat the vial with the blow dryer first, about how long should i heat it? Also, I sould heat and shake it, to get it back in,right?

Heat it until it's as hot as you can get it with the dryer. Or fill a bowl with HOT water and set the vial in that. If it is test crystals, it shouldn't take much heat to get them to disolve.

 

[db2]

Heat it until it's as hot as you can get it with the dryer. Or fill a bowl with HOT water and set the vial in that. If it is test crystals, it shouldn't take much heat to get them to disolve.

Thank you bro, got it done. Got them to dissolve rather quickly, heated with blow dryer in 3 intervals, about 20 seconds each, and shook it, all crystals I could see, dissolved, injected 1.5 cc about 20min ago, and it was as smooth as silk. Thanx

 

[THL]

Thank you bro, got it done. Got them to dissolve rather quickly, heated with blow dryer in 3 intervals, about 20 seconds each, and shook it, all crystals I could see, dissolved, injected 1.5 cc about 20min ago, and it was as smooth as silk. Thanx

Cool,,,,I always heat it before I inject whether I see crystals or not. Smoother injections and less pain after. Make a habit of it if you can.

 

[db2]

Cool,,,,I always heat it before I inject whether I see crystals or not. Smoother injections and less pain after. Make a habit of it if you can.

Yes, definately will be part of pre injection routine. Although my bitch ass, has a hard time holding the vial once that shit starts to get hot. lol. worked like a charm tho. thanx again