Titanium Gear Industries (domestic source)

Appreciate the insight guys. I will always welcome constructive comments. Thanks.
98-104°C is the melting temperature of DHB, you can safely heat it below about 208°F without any negative effect. In fact most AAS besides tren are fine with heat.

Heat is really a relative term. Raising the temperature from 60 to 90 or 600 to 900 hundred is still heating. I’ve used this analogy multiple times regarding heat and Ass. You can wash your dishes with soap and cold water and they still become clean. Use warm to hot water and it’s just easier. Same as aas. You can heat every steroid there is. It’s the total temp that matters. My only conclusion about cloudy finished is one of two or both of these. Either there is an impurity in the raw or moisture. Some impurity’s may be able to be filtered. So a cold filter may help. However if it’s moisture heat will be the only thing that gets it out. So depending on the raw would determine how much heat. I made pus for Tren a and was able to turn it clear by low and slow heat and it stayed.
 
Ive been following this thread all along. Definitely will try him out once his primo comes around. Been using the same 2 guys for a long ass time but always seeking backup
 
Ive been following this thread all along. Definitely will try him out once his primo comes around. Been using the same 2 guys for a long ass time but always seeking backup
Primo is going to be my next (probably last) addition to things i brew. Still far off though. After primo i will look into the HGH market and that will be the extent of my offerings.
 
Back
Top