Titanium Gear Industries (domestic source)

Bro! Thanks to you and @roger Rabitt ! That was the best advice! I injected right where you said and only half inch in and it felt like I didnt even pin anything!
Thats what it's all about bro. Being on this forum has made my life so much easier because of the advice I've gotten on here, so I try and do the same for people, and @Roger rabbit is the KING of good advice lol. You're welcome bro I'm glad to help and I'm glad that it went well for you. You can deposit mine and Roger Rabbits $50 service fees to our respective BTC addresses. Next time I will give you 20% off for being a return customer.

Bro and just so you know, you can go all the way in with that 1 inch. Trust me I do it all of the time...every single time. That way you don't have to jockey the pin and risk not going deep enough. Dont go longer than 1 inch, but bury that sucker and get it deep in that tissue.
 
Plus for me at least .. when I pin say 1ml... I know it's very little but like some is lost in pin.. a little always oozing out the needle... And when I pin my delt.. even going in 1.5 inches .. some gear always oozes out of my shoulder. . So if I'm aiming 100mg of something, with that I lose .. what oozes out... if it's like 120 mg per ml I'm probably losing that extra shit and getting what my original goal was anyway. IM JUST TRYING TO BRIGHTEN YOUR MORNING! Don't kill me if I'm reaching a bit

It’s possible that you’re engaging the muscle: I’ve had oil leak out a few times, like less than 10x. When I’ve made sure the muscle was relaxed I never had oil leak out. Easiest to do in the quad, followed by glutes or anywhere else in the leg area. Z track will help but make sure everything is relaxed. Even when it did leak it looked like a lot but I think at most ~.1ml. If you still can’t keep it from leaking do the air lock method, that way anything that leaks out would have been wasted anyway.
 
Back
Top