Hello everyone,i ordered tren ace from Landmarkchem.I have all the stuff needed,but i am curious if i can make the solution stable only using grapeseed oil and BA(no BB).Some say that it can remain stable without BB,others say that it's of crucial importance ,especially for trenbolone.Can i pin it even crashed,or i must heat it or something to remove the crash.(offtopic question) It's the 5th day from my order and track number still not appearing on cainiao site tracking,should i worry?
MESO-Rx
Anabolic Steroids
Tren ace homebrew,need your help
- Thread starter spirit
- Start date
Andre silva
New Member
bb and essential because it realizes that the connection of the ester oil. it is the solvent. BA can be done without , but is not recommended. All I have are with ba and bb and look great and painless .
You do not want to pin crashed gear! You'll be experiencing some terrible PIP.
Jakan
New Member
Pin crushed gear ? If you use it, you use only BB,oil and BA. Crystals will stay in bottle :-D
You must heat it till all is liquid, wait to good temperature to app. But next day probably be crushed again and you must again heat....
You must heat it till all is liquid, wait to good temperature to app. But next day probably be crushed again and you must again heat....
BA is what keeps the solution bacteriostatic. You cannot go without BA unless you want to filter the solution before every injection.
To get tren ace to hold at a reasonable concentration you'll need BB (I don't know why your not want to use it when it's needed anyway). You could try to go without it but it will crash regularly and you'll need to heat it before every pin most likely and that might work or might not.
Andre silva
New Member
It is possible to have injetable methandienone
Using ba bb powder and oil ?
similar to winstrol ?
Andre silva
New Member
Andre silva
New Member
[/IMG]
Or can I use 190 proof grain and PEG300 to have dianabol?
Ripp
Member
My appologies spirit, I do not mean to highjack your thread, but can I get some experienced ppl tell me what levels of ba they know works effectively for Tren, but not have harsh pip? I was reading 2% ba, is that really necessary?
For example, 10g Tren, 18% bb, 2% ba, 71.5 oil= 100ml 100mg per ml.
Could a guy get away with cutting back on the ba and adding oil? Or, is 2% necessary?
For example, 10g Tren, 18% bb, 2% ba, 71.5 oil= 100ml 100mg per ml.
Could a guy get away with cutting back on the ba and adding oil? Or, is 2% necessary?
kap73
New Member
Alot of guys here use 1% BA, i think pharma companys use slighty less
Gives you big balls? Sexy...
I use 1%. Most people probably use 2%. Anything more than 2% is just silly, imo.
Ripp
Member
Thank you for your input. I think a lower ba is in order then. Much appreciated.
Ripp
Member
Gotcha, 1%. Thank you for your help. I would never wish to go over 2% either.
Ripp
Member
Is that what those hard knots at the injection site are from? Too much ba? Or could it be dirty gear? Meaning impurities in the solution. I was thinking to filter another time.
