painful testosterone enanthate powder

[mjf]

My test e homebrew never crashed or got cloudy, but was causing pretty bad pip. I just boxed up approx 400ml of brewed test e to throw away ranging from 300mg/ml 250mg, down to 200mg. All were causing pip so I brewed more. It really does pain me to throw it all out, but limping for 4 days when you take a shot every wed and sat sucks.

Some of my powder had melted from being in the bathroom while I showered before starting to brew it.

 

[Dogggy]

Whatever that cloudyness is, gave me pip so bad I this is day six having a hard time walking, a hot bath helps but it's still there, I just want to throw it all away!

 

[Dogggy]

Well I decided to salvage the gear, pop all the caps, refilter every bottle, so far no cloudyness

 

[mjf]

I just used the last of my test e raws try to brew without pip. I used all new bb, ba, and mct just in case my chemicals had been sitting too long.

Used 10%bb, 1% ba like I do with all raws except tren, which requires more bb usually. Made it at 200mg. Brewed the same as I always do. For reference, I brewed npp and prop recently and you don't even know where you pinned it the next day so I don't think my technique is bad.

I did a test pin(1ml) and had pip within a few hours. Not unbearable and I did it in the delt which is one of my spots that hurts the most. This was done just to measure pip.

I'm sure I'm not bright enough to wash my test e as I've seen referenced on other sites if it's actually a carbolic acid issue. Plus I'd never try it until I read it here from a few respected brewers. So I'm thinking of just switching to test c from now on. What exactly are the issues with brewing test c? I've read it's problematic to brew.

 

[ickyrica]

So I'm thinking of just switching to test c from now on. What exactly are the issues with brewing test c? I've read it's problematic to brew.

Cyp is very easy to brew. Up your BB to 18%, use a low heat when brewing and give it time, mix adequately when heating. Same as Test E, just a little more BB really.

 

[blowingup72]

hey every one. since I posted this i have not had any problems with the new powder I received. every thing is back the way it should be.

I have started refridgerating my test e powder and have had zero problems.

I'm sure the fact that it was melting and rehardening for several months in my closet had caused the powder to become a painful mixture when brewed.

As for the swirl in my older vials, I believe that was the shitty powder crashing. No amount of different solutions helped make the powder stay suspended.

Good luck guys.

 

[blowingup72]

Cyp is very easy to brew. Up your BB to 18%, use a low heat when brewing and give it time, mix adequately when heating. Same as Test E, just a little more BB really.

I got into the habit of letting some powder and BB/BA mixes sit overnight before adding any heat to melt what's left over. I hated mixing and mixing the stuff over the stove for long periods of time. Letting everything sit together for a while helps.