So bb doesn't cause the pip? Is it when it falls out of solution?
MESO-Rx
Anabolic Steroids
Recipe thread
- Thread starter Robfromga
- Start date
picholas
New Member
BB lowers the viscosity which makes for an easier injection and prevents the hormone from crystallization. I haven't noticed a difference in PIP with BB% in the 15-22% range. After 25% it starts to kick.
Good info .
So since it's my first time should I just use 20% bb or is that unnecessary?
picholas
New Member
With Test E you could start at 10% BB I guess and adjust from there.
With Test C, I really don't think you'll have an issue if you do it at 2/18. Again just add the solvents and give it a bit before adding any heat.
So just give it a go, keep track of your ratios and numbers and be able to adjust AKA save some raws in case you need to improvise.
Rigger622
Member
I have not tried to brew cyp for that reason, not that I think it would be hard to do but test E was just what I went with. Doing my research for cyp I would agree with what picholas said above and go with 2/18 @250. I use a magnetic stirrer/hotplate its the shit, now that I have used it I wouldn't brew without.
Yeah, I'm only doing a small run to test it
Yeah...I need to order one .
Exclusive of noobs w a virgin arse, some still wonder where PIP comes from. Heres a hint compare your brews to that of Pharma AAS in the same class.
Pharma uses select solutes and solvents in their AAS for good reason, evidence based pharmacological data, and it should be no surprise those who insist upon experimenting with the solubility envelope develop side effects.
Last edited:
picholas
New Member
Brewed just 20mL of 150 TPP with 2/20
Did another 70mL of 100 TPP with 2/20
Will let you know where it's at in the morning.
What's tpp? Test phen prop?
picholas
New Member
Yeah, same ester as NPP attached to Test
Ahhhh! Are you using the same formula as npp?
picholas
New Member
Yeah used the same one.
150 and 100 both holding at same recipe of 2/20 which is nice to know. Duct tape on the 150 one so I didn't forget over night lol
Attachments
Dude...the 150 is holding? Any EO?
picholas
New Member
No problem brother. Most of my stuff is in the Water Boy thread I posted in the underground if you want to take a look.
I'll PM you the rest
I used the same recipe for both... I think it's 18/1 or so... Maybe 19. Forget off hand.
I use mct instead of gso, I think that makes a slight difference.
picholas
New Member
I've been experimenting with GSO and MCT, so far it is in line with what you said. Normally I find GSO needs about 2/20 and MCT needs 2/18. Maybe it's the viscosity difference?
Did it hold man?
