TorroXL
Member
Stuff you made at 150 was great. Pip was minimal and gains were legit. Only issue was my room was cool so it’d crash. I’d put it in my toaster for 10 minutes and it was normal again.
MESO-Rx
Anabolic Steroids
Stanford Pharmaceuticals
- Thread starter Stanfordpharma1
- Start date
Stuff you made at 150 was great. Pip was minimal and gains were legit. Only issue was my room was cool so it’d crash. I’d put it in my toaster for 10 minutes and it was normal again.
Yeah, i started at 200mg and went to 150mg and it still didn't hold. Holds at 100mg, barely.
MoonKnight
New Member
Thanks for the info. Trying to figure out if I fucked up somehow when heating it up or my body hates EO. And I can’t remember if I’ve tried anything with EO in it before. But I’m assuming it’s the EO.
Glad to hear the lower concentrated stuff doesn’t cause those reactions. I’ll give the 100mg a go and see how I react to it.
I also want to point that this has nothing to do with SP quality and customer service because it has all been top notch.
Sp check your email homie trying to add something to an order before it goes out thanks
The EO struggle is real.
EO absolutely beats me up! I used SP Primo 200mg in EO and the PIP was BRUTAL!!!
I had to stop using it and donated it to a friend. Pain and swelling that lasted more than a week. Limping, struggles sleeping, uncomfortable sitting. Not good!!!
Savagesteve
Well-known Member
The EO in the primo killed me as well. Worked out for a buddy of mine lol
What I did was take the G.S.O. 150 and mix it with a half a milliliter of the 200. Worked great. Mwf for 750 a week and had amazing results.
I'm glad that worked for you, but I was not so lucky, my friend. I tried warming it, diluting it, having it blessed by a Catholic priest... I tried everything. Even as little 0.5 ml STILL made life uncomfortable.
And this wasn't an SP problem, unfortunately some of us just do not tolerate EO.
Does anyone have any advice to get the crystals to go back into the formula on his test no ester? I have a shit ton of crystals in it and it just seems like a waste. I tried heating it up but it didn’t seem to do anything and I don’t want to ruin it either.
MoonKnight
New Member
I’ll give this a try if I give it another try. But I’ll more than likely try the 100.
1ml diluted with .5 ml of Test was a pain in the ass. So I just sucked it up and was doing 2ml at once lol. This may have been part of the issue.
If gear crashes consistently and you inject it does it start to crystallize again inside the body? Just curious.
Roger rabbit
Well-known Member
Yes it can cause a steril abscess.
You do not want to keep injecting in the same spot.
T-Bagger
Elite
When you say you heated it, how exactly did you heat it?
T-Bagger
Elite
@StanfordPharma have you changed your Primo 200 formula or are you still using 100% EO?
Can you check your email when you get a chance?
Can you check your email when you get a chance?
First tried holding it under hot water running from the sink. Then tried boiling a cup of water in the microwave, let it cool for a minute then placed it in it and took it out and shook it up a few times. Still nothing
T-Bagger
Elite
When my gear crashed, I wrapped my vials in foil and put them in boiling water until they dissolved, probably about 3-4 minutes. Granted, it was Cyp and Sust, but it took care of the crystals. I think I also did it to a Tren/Cyp/Mast blend.
TorroXL
Member
Toaster oven at 180 for 10-15 min
Primo 200 is eo, primo 150 is gso.
I put in oven at 215f for about 30 to 45 minutes and then shake vigurously once I'm barely able to handle.
Sorry guys. So very busy. Trying to take care of a rush of orders and questions. Doing my best. Also, went out of town this past weekend and got home yesterday to an email from my provider saying email wasnt working properly over the weekend and alot of emails weren't delivered and weren't sent. If you didn't get a reply please email again.....ohhhhhh boy. Here comes a flood of emails, lol.
Btw, once I switched to the 150mg in GSO it was smooth sailing from there.
