Here’s a little story...
When I use to lurk on meso (while still being a member) I would think that sometimes the vetting was rough af! Each time that I would order in the past though I went with the vets here and never had any issues with the sources I used.
The one and only time I decided to go against what the vets were saying about a source in a sources thread is when I had the only bad experience with any source thus far.
I wanted to give homebrew a try. This source was offering domestic raws along with finished products. While placing an initial order for raws I decided to just order some finished Test and Tren instead for a trial order to see how things went. I ordered 3 of each and he threw in a vial of each. So I had 4 Test E and 4 Tren A. It was fairly quick to order and receive the products but...
Upon inspection of the finished oils I noticed EVERY SINGLE VIAL HAD FLOATERS INSIDE! Not just small ones! Shit looked liked pieces of saw dust. Of course I immediately contacted the source. He emailed me back saying I was just one of the ‘source bashers’ here at Meso just trying to bring him down. This was even after I’d emailed him pics of the products!
I did refilter each vial but i didn’t even pin it afterwards. I eventually just tossed it out.
Anyway I contacted a member I respected here to ask for advice on how to go about it and get the information out about that source. Seeing I never posted and was new to everyone here because of that, I didn’t know how to go about it.
Btw, THANKS for that again @Roger rabbit I was and still am grateful for your help in that matter!
The source then was The Brewkit.
In short, I went against the better judgement of the vets here and ordered anyway. I got my shit but really got burned because it wasn’t useable even after I refiltered it (in my eyes anyway).
There’s a reason for the vetting process and it is needed here without any doubt as long as it helps members and sources in a constructive manner. Which anyway you look at it, harsh or not, it always has and still does!
When I use to lurk on meso (while still being a member) I would think that sometimes the vetting was rough af! Each time that I would order in the past though I went with the vets here and never had any issues with the sources I used.
The one and only time I decided to go against what the vets were saying about a source in a sources thread is when I had the only bad experience with any source thus far.
I wanted to give homebrew a try. This source was offering domestic raws along with finished products. While placing an initial order for raws I decided to just order some finished Test and Tren instead for a trial order to see how things went. I ordered 3 of each and he threw in a vial of each. So I had 4 Test E and 4 Tren A. It was fairly quick to order and receive the products but...
Upon inspection of the finished oils I noticed EVERY SINGLE VIAL HAD FLOATERS INSIDE! Not just small ones! Shit looked liked pieces of saw dust. Of course I immediately contacted the source. He emailed me back saying I was just one of the ‘source bashers’ here at Meso just trying to bring him down. This was even after I’d emailed him pics of the products!
I did refilter each vial but i didn’t even pin it afterwards. I eventually just tossed it out.
Anyway I contacted a member I respected here to ask for advice on how to go about it and get the information out about that source. Seeing I never posted and was new to everyone here because of that, I didn’t know how to go about it.
Btw, THANKS for that again @Roger rabbit I was and still am grateful for your help in that matter!
The source then was The Brewkit.
In short, I went against the better judgement of the vets here and ordered anyway. I got my shit but really got burned because it wasn’t useable even after I refiltered it (in my eyes anyway).
There’s a reason for the vetting process and it is needed here without any doubt as long as it helps members and sources in a constructive manner. Which anyway you look at it, harsh or not, it always has and still does!