What the hell, 1.5inch and the oil came back out of me

[TigerStyle1]

I injected 2.5ml's of Test enan in my glute using a 23g 1.5" needle......had the needle pushed ALL THE WAY IN and injected in the area of the upper outside area of the glute exactly how spotinjections shows glute injects.

Anyway when I pulled the pin out I swear to god all 2.5ml's came out of the injection hole and ran down my leg!!!!! WTF I had a stream of oil run down to to the back of my knee.

 

[bronco944]

mighta hit scar tissue, or you withdrew teh needle to fast. try injecting a small amount of air at the end of the injection, or stretching the skin by pulling it to one side, injecting then as soon as you pull the needle out let the skin go, that will cover up the whole.

 

[Dizzy26]

I've had oil come back out after an injection...not as much as that though. I usually press the palm of my hand over the area right after I take the needle out and message it in. I use a 1" 23g needle for all my injections. Applying pressure also reduces bleeding in the skin to prevent bruising. Good idea when you do injections in your shoulder. Makes the fact your juicing a little less noticable to people in the gym.

 

[bg65]

do like bronco said and pull the skin to the side before you inject, holding it there while you are injecting, then after you pull out the pin let go of the skin that way the hole in your skin won't line up with the hole in your muscle.

 

[TigerStyle1]

Yeah I'm familiar with this method of injection, its called the z-lock method. However the oil would have just run out of the muscle essentially making it a subcutaneous injection.

It is really beginning to bother me that alot of the gear I've previously injected has run out of the muscle and become subcutaneous.....

If you were to inject gear subcutaneously how would it effect absorption of the hormone???

 

[Dizzy26]

Yeah I'm familiar with this method of injection, its called the z-lock method. However the oil would have just run out of the muscle essentially making it a subcutaneous injection.

It is really beginning to bother me that alot of the gear I've injected has run out of the muscle and become subcutaneous.....

HOW MUCH DOES THAT AFFECT ABSORBTION OF THE HORMONE???

Exactly....so....like I said, just apply pressure. It will close up the hole, stop the bleeding and you can message the oil into the muscle.

SubQ fat will absorb the hormone and release it very slowly and speratically.

 

[moralanimal]

I am not sure if this is what is going on but I had a similiar issue due to scar tissue. Basically my glutes are done. Do you use any other injection sites?

 

[P.E.]

next tiem do this pull the skin over where ur about to inject hold the skin there put the needle in and push the shit in after takin the need out let go of ur skin...it like closes the hole...it works 4 me....try it

 

[rtlltj]

i've only had a small droplet appear. nothing more but that was my first cycle so fresh site injects, and no scar tissue.

 

[Dizzy26]

I am not sure if this is what is going on but I had a similiar issue due to scar tissue. Basically my glutes are done. Do you use any other injection sites?

You can also use your Quads and Delts to inject. No more then 1cc in your Delts and 1.5cc in your Quads in one spot.

 

[esco]

You can also use your Quads and Delts to inject. No more then 1cc in your Delts and 1.5cc in your Quads in one spot.

why do you say not more then 1.5 cc's in your quad in one spot? you can do more then 1.5 cc's in one spot in the quad.

 

[desert]

I injected 2.5ml's of Test enan in my glute using a 23g 1.5" needle......had the needle pushed ALL THE WAY IN and injected in the area of the upper outside area of the glute exactly how spotinjections shows glute injects.

Anyway when I pulled the pin out I swear to god all 2.5ml's came out of the injection hole and ran down my leg!!!!! WTF I had a stream of oil run down to to the back of my knee.

A 23G...dam that must have taken 5 minutes to get all the gear out. Have you considered doing a 1.25ml shot in each glute instead? I like pulling the skin though, never lost a drop since I've started that.

 

[drl]

be careful w/ the shoulders, as well- i think i finally maxed mine out w/ scar tissue i did a 3 cc inject w/ test, eq, and primo the other day in my right delt, and the next day it hurt a little, and the next two days a little bit more. to make a long story short, pretty much the entire injection didn't get absorbed by the muscle, and is now sitting on top of the outside of my bicep in a giant red swollen spot that looks like an inner tube. i am about 5% bf right now, so it is very noticeable, but i know from experience that it will go away after a few days- but it does suck

 

[TigerStyle1]

A 23G...dam that must have taken 5 minutes to get all the gear out. Have you considered doing a 1.25ml shot in each glute instead? I like pulling the skin though, never lost a drop since I've started that.

Actually if you heat the oil up it takes less then 20 seconds to inject 2ml's through a 23 guage. I'm used to using 25 gauge and have learned if you heat the vials of gear up it by boiling them in water for about a minute the gear become unbelievable easier to draw and shoot.

I think this was the problem....I hadn't used a 23g in a while and had heated the oil a little too much.....injected too fast and withdrew the needle to fast.