narta
Member
Yes, but can you walk after sticking it in your butt?
MESO-Rx
Anabolic Steroids
Where did I screw up?
- Thread starter alfanot
- Start date
Why wouldn't you? BB doesn't cause pip. There's a pharmaceutical recipe posted here with 45% BB. Most pharma in general is 25%
Deskoze38192
Member
Oh you emailed and asked?
Trust me bro lol
Nice first post
and why you downvoting everyone’s posts in here? The posts you downvoted were accurate and helpful to the OP.
What do you brew Test C at with what solvent and co-solvent ratio? And what is your recommendation for the issue the OP is having?
Instead of being a problem be part of the solution
Qualityoflife86
Member
Haha.345mg/ml Test C without super solvents?
narta
Member
Did I ask that? My brews have 30% BB and are smooth as butter. Test C at 400mg/ml though... If a source had a pipless Test C at that concentration without supersolvents they surely would share the recipe with you
I brew at 350 with only 2/22. It's not difficult. Just because you don't share the recipes on reddit doesn't mean they don't work lol. The posts I downvoted (seriously who gives a fuck about downvoting lol), were based on personal opinion. Not fact. Don't get so butthurt over le internet points.
"The concentration is too high for cypionate. You'd want to keep test cyp at 200-250, maybe 275mg/ml"
Wrong.
"The oil can only dissolve 250mg per ml and the rest gets stock during filtration"
Wrong.
"345mg/ml Test C without super solvents?"
And also wrong
I'd recommend the original poster test his raws
Ok lol. Believe what you wish. Either you've never tried, or you don't know how to brew. The fact you use 30%bb makes me think the latter.Did I ask that? My brews have 30% BB and are smooth as butter. Test C at 400mg/ml though... If a source had a pipless Test C at that concentration without supersolvents they surely would share the recipe with you
So why not try yourself? Make a 10ml batch and inject it. 2/24 mct
narta
Member
narta
Member
mf I was brewing test when you were amino acids on your fathers balls
I'm sure lmfao. 30%bb hahahahahaha
narta
Member
Deskoze38192
Member
I share my brewing recipes and experience on this site, like an adult.
I brew Test C @ 300 mg/ml 2/20 currently and it crashes at temps below 50 degrees F which is fine for me because I don’t live where it gets too cold but for an average brewer getting up above 275 mg/ml with Test C (as mentioned) could cause issues for some with reasonable solvent use.
Test E is better suited for higher concentrations (as mentioned)
Brewing Test C at high concentrations is like using a hammer to screw in a screw. Not very sensible
Last edited:
Raws are from QSC.
Unsure how the math could be fucked up. 3.3g raws, 2ml BB, 0.2ml BA, rest mig840. Total filtered was 10ml using a 10ml syringe with syringe filter.
narta
Member
Send raws for testing
Similar threads
