Which oil is more similar to the pharma test c oil Mct oil or GSO ? Looking for experiences which gives less side effects or pip thanks

Most of my prescribed test was cotton seed oil. I’d imagine (based purely on viscosity feelz when drawing and pinning) it would be somewhere between those two you listed.

It seems some people get slight pip/complaints with MCT. I’ve done both and although I prefer GSO, I’d have no problems stocking up on MCT.


Unless you’re allergic or have some adverse reaction to a certain carrier oil, it really doesn’t matter.
 
Most of my prescribed test was cotton seed oil. I’d imagine (based purely on viscosity feelz when drawing and pinning) it would be somewhere between those two you listed.

It seems some people get slight pip/complaints with MCT. I’ve done both and although I prefer GSO, I’d have no problems stocking up on MCT.


Unless you’re allergic or have some adverse reaction to a certain carrier oil, it really doesn’t matter.
Yea my pharma stuff is cottonseed oil. Thanks for your experience. Might grab some each just in case.
 
My bottles from the compounding pharmacy say grape seed oil on them
This is the case with my ones too but many people say MCT oil is very thin n much easier to draw n inject, imo it really depends on the person as I have used the GSO oil pharma grade stuff I get from the compounding pharmacy n only had PIP like a couple times even on shots that were done pretty messy n where blood was spurting out cos I nicked a vein otw out (or pulling out to quick), it’s almost like my butt recognises it’s test n just wants to slurp it up ahah PAUSE.

Jk aside tho I’d say try both n figure out what’s best for you, lots of UGLs use MCT but imo it’s a minimal difference, the stuff to avoid is like tea oil or whatever it’s called some people were saying that was makin some insane nasty effects on their IM sites, that n ethyl oleate seem to have the worst effects but even then it’s very dependent on the individual
 
This is the case with my ones too but many people say MCT oil is very thin n much easier to draw n inject, imo it really depends on the person as I have used the GSO oil pharma grade stuff I get from the compounding pharmacy n only had PIP like a couple times even on shots that were done pretty messy n where blood was spurting out cos I nicked a vein otw out (or pulling out to quick), it’s almost like my butt recognises it’s test n just wants to slurp it up ahah PAUSE.

Jk aside tho I’d say try both n figure out what’s best for you, lots of UGLs use MCT but imo it’s a minimal difference, the stuff to avoid is like tea oil or whatever it’s called some people were saying that was makin some insane nasty effects on their IM sites, that n ethyl oleate seem to have the worst effects but even then it’s very dependent on the individual
Ya I'm going to try MCT oil in the future for other compunds. For daily shots I want to see how much easier it is to draw MCT through a slin pin. Even slightly warmed up it took forever to prep a weeks worth of shots of Mast P in GSO. I had some Ment that was in a thinner oil, they didnt say what kind, but that was much easier to deal with.
 
Ya I'm going to try MCT oil in the future for other compunds. For daily shots I want to see how much easier it is to draw MCT through a slin pin. Even slightly warmed up it took forever to prep a weeks worth of shots of Mast P in GSO. I had some Ment that was in a thinner oil, they didnt say what kind, but that was much easier to deal with.
Yeah give it a try it seems to be pretty popular, unrelated but why you prepping your shots beforehand? Isn’t that conducive to having contamination or regardless not ideal for the compounds staying in the pins for too long? I’m asking just cos I’m genuinely curious but ik people do that so it ain’t as bad as others make it seem
 
Yeah give it a try it seems to be pretty popular, unrelated but why you prepping your shots beforehand? Isn’t that conducive to having contamination or regardless not ideal for the compounds staying in the pins for too long? I’m asking just cos I’m genuinely curious but ik people do that so it ain’t as bad as others make it seem
It's just easier when I'm doing 2 daily shots. If I'm swabbing everything with alcohol beforehand I don't see why it would be an issue. I've never noticed an issue with the compund in the pins degrading the rubber or anything. With my twice a week test shots I just prep them right before I inject.
 
It's just easier when I'm doing 2 daily shots. If I'm swabbing everything with alcohol beforehand I don't see why it would be an issue. I've never noticed an issue with the compund in the pins degrading the rubber or anything. With my twice a week test shots I just prep them right before I inject.
Ah word I understood wrong as in I thought you were prepping your whole week of shots one day then just leaving the loaded pins layin somewhere til you used em ahah
 
Ah word I understood wrong as in I thought you were prepping your whole week of shots one day then just leaving the loaded pins layin somewhere til you used em ahah
That is what I do. Like my last cycle I loaded up 7 slin pins of Mast P & 7 of Ment every Saturday. But my twice a week Test cyp I just loaded right before pinning.
There's a TRT clinic out there that sends their patients like 8 weeks of preloaded syringes. As long as your following proper protocol and keeping everything clean should be fine
 
My bottles from the compounding pharmacy say grape seed oil on them
GSO gives me the worst PIP ever. As in bad lumps that can last a week plus (red, itchy swollen and painful.) I am good with Cotton Seed or Sesame Seed oil. Hoping to try to some MCT soon since I am using insulin pins and it takes a loooonng time to draw.
 
Ya I'm going to try MCT oil in the future for other compunds. For daily shots I want to see how much easier it is to draw MCT through a slin pin. Even slightly warmed up it took forever to prep a weeks worth of shots of Mast P in GSO. I had some Ment that was in a thinner oil, they didnt say what kind, but that was much easier to deal with.

Hey i prep a week's worth of test E in castor oil which is the thickest of all, it takes me 20 min to backload from a 21g to 7 slin 29g pins. It's not that bad, i mean if it was a thinner oil i could save 5 minuntes? Do you draw from a vial with the slins or do you backload? Because if you draw, then yeah..it takes forever. Try backloading them, also it's a bonus you don't dull your needles and keep em completely sterile.

Yeah give it a try it seems to be pretty popular, unrelated but why you prepping your shots beforehand? Isn’t that conducive to having contamination or regardless not ideal for the compounds staying in the pins for too long? I’m asking just cos I’m genuinely curious but ik people do that so it ain’t as bad as others make it seem

I do it because the pharma test i use comes only in amps, so i either have to transfer couple amps to a sterile vial or crack an amp and prefill a week's worth. I do the latter because it's ez to use, i take a slin pin from the drawer, heat it up for 10 seconds with hairdryer and jab. If test is brewed with BA and BB, as the most of them, it's almost impossible to have an infection from that. You transfer oil from a sterile container to another sterile container, the only interaction will be the oxygen in the air but BB and BA take care of that. On the other hand if the oil contains strong solvents there's a chance of degrading the rubber piston, so in that case you either avoid it or otherwise you have to draw the plunger back and put the syringes upside down so the oil doesn't touch the rubber.
 
Hey i prep a week's worth of test E in castor oil which is the thickest of all, it takes me 20 min to backload from a 21g to 7 slin 29g pins. It's not that bad, i mean if it was a thinner oil i could save 5 minuntes? Do you draw from a vial with the slins or do you backload? Because if you draw, then yeah..it takes forever. Try backloading them, also it's a bonus you don't dull your needles and keep em completely sterile.



I do it because the pharma test i use comes only in amps, so i either have to transfer couple amps to a sterile vial or crack an amp and prefill a week's worth. I do the latter because it's ez to use, i take a slin pin from the drawer, heat it up for 10 seconds with hairdryer and jab. If test is brewed with BA and BB, as the most of them, it's almost impossible to have an infection from that. You transfer oil from a sterile container to another sterile container, the only interaction will be the oxygen in the air but BB and BA take care of that. On the other hand if the oil contains strong solvents there's a chance of degrading the rubber piston, so in that case you either avoid it or otherwise you have to draw the plunger back and put the syringes upside down so the oil doesn't touch the rubber.
Oh word fair enough that makes sense yeah I love the aesthetic of amps but it seems like they would be a pain in the ass to dose how you would want (like either you use it all immediately or if not you’re right that’s the only other option n now it makes total sense)
 
I swear I think ur trolling half the time.
haha sometimes i troll but no really it was peanut oil. it wasnt american tho it was organon from india. I was surpised too i was thinking man wtf peanut oil thats weird. But EO or Grape seed oil are my go tos. I never have issues with any carrier oils most of the time MCT gave me some pain but not to bad at all. Ive never actually used any american pharma test since ive never actually got a script for it so maybe this doesnt count.
 
Back
Top