It's only possible to get 330mg of test I'm 1cc is this true

[drizzy]

Hey guys im all over the place I've been a member almost two years, so there's a new thing going around online rite now. Supposedly it's literally impossible to get more then 330mgs of testosterone in 1cc. Of oil someone please get dr. Jim

 

[Dr JIM]

The answer to the question?

It depends upon which ester of TT your using as the solute. Why because as more TT is added to the oil a precipitate occurs especially when the solution is cooled.

But as a general rule the lower molecular weight esters, acetate and propionate are relatively insoluble and not much more than 100mg/ml will dissolve before precipitation occurs.

The larger esters, cypionate, enanthate, and decnonate are much more soluble and dilutions of 250/300/400 mg/ml are usually
achievable before precip occurs.

One can improve the solubility characteristics of the TT-ester chosen by either using an oil with a higher LD/50, safflower oil is one example.

However it's obviously quite expensive to use "in volume", so many UGL opt for more Benzyl Alcohol, which is a frequent cause of PIP in T-p or T-a, but BA is cheap.

Moral of the story, labs that sell AAS with PIP are cheap asses, and are best avoided IMO.

Regs
Jim

 

[foreveryoung]

I've heard ethyl oleate can hold a higher concentration too

 

[drizzy]

But I've gotten a ton of pip from pharmatec sust amps and I know they where legit cause I had one tested. But I guess there oil is very thick.

 

[Dr JIM]

OP perhaps you didn't know but I was stamping out disease kicking pain and suffering between the balls, in the ED trauma bay, when notified a had a "Meso alert" pending a reply.

Thank goodness

But I've gotten a ton of pip from pharmatec sust amps and I know they where legit cause I had one tested. But I guess there oil is very thick.

-------------------------------------------------------------------------------------------------

Pharm grade PIP also occurs from BA since their concentration can be above 2%

However what typically differentiates PH Grade PIP from UGL, the duration of the former is limited to roughly 36 hours.

Moreover the latter is not only "more intense" but also of a longer duration, such that some folks can't lift for as much as one week AFTER the pinning.
jim

 

[ATodd]

Short answer: You can get more hormone in at higher levels than 330mg/mL. It depends on the hormone, amount of BA, BB, EO, or which oil you use. Different esters can also have a synergystic affect on others solubility, when used in the same solution.
atodd

 

[drizzy]

Thanks a ton I love this forum lmao, I was actually planning on going to school for pharmaceuticals years back when I was fresh out of high school. But was to paranoid on having a ton of debt, dr Jim your the man brother. But are those bayer test e amps still being made just curious?