Labmax test results

[n]MFL Mast P - PASS[/b]
As usual, I was unable to get the camera in place fast enough to pick up the A test initial green color. Also the UV pic isn't that great. It's difficult to see in the pic, but there's definitely orange in there (confirmed by someone NOT color blind).

12807
12808
12809
 

Attachments

  • mf_mastp_a.JPG
    mf_mastp_a.JPG
    36.4 KB · Views: 237
  • mf_mastp_b.JPG
    mf_mastp_b.JPG
    32.6 KB · Views: 229
  • mf_mastp_uv.JPG
    mf_mastp_uv.JPG
    34.2 KB · Views: 230
MFL Tren A - PASS
I decided to skip the test prop. With everything else passing, there's no reason to test the cheapest product on the list. They kindly offered store credit for the cost of each test if anyone else wants to do it.

12810
12811
12812
 

Attachments

  • mf_trena_a.JPG
    mf_trena_a.JPG
    35.1 KB · Views: 224
  • mf_trena_b.JPG
    mf_trena_b.JPG
    34.7 KB · Views: 222
  • mf_trena_uv.JPG
    mf_trena_uv.JPG
    38.6 KB · Views: 225
Flenser how long was the Mast P done before pic? I'm confused I saw earlier Mast tests that it shows a lighter green. My test of Mast showed green for like two seconds then turned dark instantly I assumed the Mast was bad. My tube B went dark also. Would that happen if using too much Mast?
 
Flenser how long was the Mast P done before pic? I'm confused I saw earlier Mast tests that it shows a lighter green. My test of Mast showed green for like two seconds then turned dark instantly I assumed the Mast was bad. My tube B went dark also. Would that happen if using too much Mast?

Yeah, 2 seconds of green is about what I get on what I believe is a good sample. That's with 1 or 2 drops from the syringe. In the MFL pic, you can still see a slight green tinge after the 5 or so seconds it took me to get setup. I'm all thumbs when doing this stuff, holding a sharp object, trying to set the vial back down upright, reaching for the camera. The more important test is the UV orange result IMO.

I don't know how much is too much, but I've gotten OK results with 6-7 drops. Unless you, say, doubled the volume in the vial, I would think it would still work, only it would darken a lot quicker.

Who's mast were you testing?
 
It was Power Pharma I have pics of his gear and vial A but I forgot to snap pic of B and under UV . I used his Mast E in the past and believed it was good. Got leaner and fuller and also had to cut back on my AI while on it.

I want to find legit Mast P and Annie. So tested Powers Mast and got Legend Anavar
 
It might be worth using another B vial if you have one. One of the two bad mast samples I tested was (I'm pretty sure) deca, and I ran a cycle with it complete with blood work and never suspected it wasn't mast. Of course, I still qualify as an aas noob, so you probably have a better idea how you react to mast and deca.
 
I ordered a lab max kit and a couple refills.

Can raw powder be used? I'm guessing just a very small amount would be needed?
 
I ordered a lab max kit and a couple refills.

Can raw powder be used? I'm guessing just a very small amount would be needed?

He has results listed for most of the powders, and yes you need a tiny amount, like what fits on the tip of a small plastic wire tie.

If you have a powder that's not listed, the difference between the powder and oil results will be the initial color in the A vial. The B and UV results should be the same, I'm told.
 
Thank you sir. It would be nice to list the results for raw powder suppliers as well but I know listing powder sources are not a good idea. I have a good bit of powders from three different suppliers.
 
Couple questions from this thread:

1) someone mentioned that a Chinese mass spectrometry system is available for around the price of four of these kits. I'm not a chemist nor familiar with how easy it might be to use but I assume this could be used more thoroughly. My search found them in the 2k range on the low end. Any links or info?

2) is it possible that this test kit will lead to partial blending of small amounts of the real (more expensive) compound with the bulk being the cheaper compound? The color spectrum/results just don't seem to be differentiating enough to detect blends...
 
Hmm a Chinese MS for around 2K?

Yea they also have generic GH which sells for under one buck per IU. No doubt the results from either are worthless!
 
Hmm a Chinese MS for around 2K?

Yea they also have generic GH which sells for under one buck per IU. No doubt the results from either are worthless!

They're using them in the bio science department at Humboldt, or so I'm told by someone that used one there...

I think the ones they have were around $3k, and I don't know who they got them from specifically, but they were of Chinese manufacture.

You don't think it would suit purposes for us at all?
 
Couple questions from this thread:

1) someone mentioned that a Chinese mass spectrometry system is available for around the price of four of these kits. I'm not a chemist nor familiar with how easy it might be to use but I assume this could be used more thoroughly. My search found them in the 2k range on the low end. Any links or info?

.

did he mention also that they are made from used Chinese newspapers
 
did he mention also that they are made from used Chinese newspapers

Actually it was me that mentioned it, and I've sense researched it more, and talked to people who have used them, and for organic matter analysis on a small scale without the need for insane levels of accuracy, they work quite well. They look like toaster ovens and are almost that simple to use.
 
So what are the correct colors? I don't see it on the chart.

It's 4th from the bottom on the first page of the color chart on the website. Gonna love to see the results of some of the UGL primo.

Metenolone Enanthate (Primobolan) (Oil)
Steroid Test A Colour Dark Orange-Brown
Steroid Test B Colour Dark Orange-Brown
Steroid Test B Colour with UV Light Yellow-Orange
 

Sponsors

Back
Top